Programming Outputs : output does not activate

[fanch]

Why not, i will try it

 

[fanch]

I tried it but result does not change.

Updating the firmware (currently V3.0) will resolve the issue ?

 

[sparkymarka]

I very much doubt it …

 

[Rulland]

Is the GSM unit deriving its power from the intruder PSU?.

 

[fanch]

Yes, but it's still powered by the battery. The relay, connected to the output and also powered by the battery, isn't activating either.

 

[Rulland]

You can't use a negative output from one supply to trigger a negative input on something else that uses a different negative.
IE all negatives should be commoned up, as there will be no common, reference, to ground.

 

[fanch]

Thanks for the cable advice, but it's not a cable problem because the other outputs work correctly. The problematic output has been tested and does activate the relay.

 

[fanch]

I'm going to test with a different output setup ("System" - "Mains Power Off" for example) and will give you feedback.

 

[fanch]

I tested another configuration "System - Mains Power Off" now it works. when I turn off the power and the output is now activated.

I don't understand why the "Aera - Fault Present" configuration does not work ?

 

[Bigsosij]

The area output may only trigger when armed