Recent content by fellmaster

I have a problem with the above. The gas top oven ignites okay but the spark is then on permenently trying to ignite the top gas rings -even when they are lit New spark generator fitted but the problem remains Funnily enough if Ikeep the front gas jet on at the same time as top oven the...

I have a problem with the above. The gas top oven ignites okay but the spark is then on permenently trying to ignite the top gas rings -even when they are lit New spark generator fitted but the problem remains Funnily enough if Ikeep the front gas jet on at the same time as top oven the...

I Do have a warranty for two years on the stat and 10 on mat the rear shows the resistance test for both after laying There is only one AUBE stat and the guarantee shows two matts laid cos of the room size. but i am not sure how they were laid about a third rectangle is warm to the feet the...

I have just had the above installed into a new conservatory . I was at work when it was installed and after a test period it appeared to be working correctly although we have not used the cons yet. because of the size of the floor area and from the paper work ,it looks like there are two mats...

hello system ideal mexico 2 non condensing altechnic expansion vessel tribune pressurised HW cylinder For no apparent reason my Ch system is losing pressure ,noisy and the rads are only luke warm even after bleeding symptoms The pressurised ex vessel loses water pressure even after...

Anyone know the best type of sealant to renovate and protect block paving. Ta fell

I thought that but I have had many attempts at prising them off ( as can be seen with on the photo )

and its a bit loose and noisy

bunged up with gunge

Tried the slot in the front face-nothing doing. Theres no clip on cover -no screws- nowt .Its a pain in the a***e

Thats the name on the extractor -well it looks like "emma"

It seems stuck and I am wary of pulling the whole unit down ta

I have an EMMA ceiling extractor in the loo. . I have no instructions and i cannot find a website. There are no apparent fixings just a slot on the downward face and one on the side panel Can anyone tell me how to remove the cover ? ta Fell