Recent content by FoxyChris

I was going to replace my current Honeywell BR91 with a Tao v3. The picture is my current working with a live loop to connection A. Can anyone confirm if I’m correct in saying the wiring to the Tado v3 would be the looped wire from L that goes to A would now go to CH COM and B to CH NO? Many thanks

I’ve got a problem with a Showerforce thermostatic shower control valve. There’s something clearly broken with it as when I turn the control knob I can feel it sticking and jumping. When you try and turn the shower off it won’t always fully close and drips. I have to keep turning the shower on...

Thanks for all your replies. I had to use a slightly shorter flexi pipe which was a much better fit and had no kinks in it. Cost me £10 and thanks to the advice on here took no time to fit it all. Working perfectly now!

It was definitely the kink in the flex pipe causing the blockages. The photos don’t show it very well but it was about a third the diameter it should be. All other pipes are free flowing now so just need to replace the flexi I think.

The pipe also seems to have a separate collar (see photos above) on the end that connects to the waste pipe going to the drain. The photo below shows the brown waste pipe just behind the tiles behind the toilet. Is the white pipe part of the flexi connector and do I need to pull this out and...

Morning all, Ever since we moved in to our house we've had an issue with the en suite toilet blocking up. Yesterday the same thing happened and my other half decided to use a plunger to try and free it up. The pressure of her using it must have been too much and the toilet started to leak...

Many thanks for the reply. The garden originally had a very slight slope towards the area where the problems are. Next doors garden is probably just less than a foot below ours and departed by a fence which I suppose acting as a retainer for the original soil. I suspect the new boards used to...

I have a large patch of artificial grass at the back of my house. One side of it is contained by some thick wood beams due to the fact that the other side of it slopes away in to next doors garden. During the wet weather we’ve been having I’ve noticed that the top layer of sand appears to be...

We have a long Tarmac drive that meets the cobbled main road by the side of the house. We are going to have sliding 3 ft high gate across the entrance but after digging out the plans for the house it would seem that every water/gas/electricity pipe in the world runs under our drive. The Tarmac...

Hi, Yes it's been serviced. I've read the manual again and it says that if you have an external controller like the one in our hall then the target flow temp should be set to the maximum 75 and the boiler will adjust and compensate. This probably explains why the temp reads in the 40's and 50's...

Then after about 5 mins this comes on.

I have the above boiler which was installed about 2 years ago and we've never had an issue with it. It's installed in a cupboard and today I noticed something on the control panel. The central heating is set to a target flow temperature of 75 degrees. However the display shows around 48 degrees...