Recent content by Fredy

Hi I have difficulty closing the above fan oven door. Also once closed it fails to remain closed once cooking. We have replaced the door twice but after a while the problem persists. Any ideas would be great Thanks in advance Fredy

Thanks Rocks. Much appreciated Fredy

Hi I have a Hotpoint WF540P On/Off light flash and also Light 1 - Wash Enhance Light 2 - Reduce Creases From other posts believe this is - f12 lights 1&2, communication error What is the solution. New PCB? Thanks in advance for help

Hi The actuator head is in a awkward position so could observe how the switch operates. Took the step of buying a new like for like mid-position valve and replacing the actuator head element. Rewired to the controller area like for like etc. Same problem HW and CH called at the same...

Sorry for the confusion Mandate As you say I replaced the motor within the 3 position valve and the problem persisted. When you talked about the Actuator Head, I thought this was a devise futher upstream so to speak which is in fact the Circulating pump as Rob884 pointed out When I...

Thanks Mandate I just around to have a look following your post.Painting the weekend as the weather was good! The Actuator Head and Valve is a Grundfos type model. I took off the plactic top cover This revealed the wiring, A spindle type control which I believe is the speed control and...

Thanks to you both I checked the HW controller and its live. It lights up to indicate that its trying to do something. I did a few other tests on the Manual/Auto Lever. When you push the Lever in the Manual Position, switch on HW and then CH the lever moves back to the mid position and...

Sorry, When you say CH side of the programmer Could you elaborate Thanks

Thanks for looking and appreciate anyhelp Now that Winter is approaching, I have set the HW and CH programme to start at same time, the HW programme is to set to stop after 1 hour and the CH to run on for another 3 hours. Previously the CH was off. However the CH only runs for the same...

I would replace the tiles rather than paint. In the shower area , old tiles are the best surface you can tile on. Nice and smooth. It also provides an additional skin or seal for the walls and the bottom of the shower tray. In the other areas such as the kitchen it depends whether you can...

Just another point to take into account ...if the area between the ceiling and the roof space or floor is small and also full of installation...the LV bulbs and transformer will generate alot of heat. Also if the cable is bunched and not spread out this will also cause a rapid buildup of heat in...

Thanks Breezer ...I will give it a whirl...Fredy

Hi... When I set the Central Heating Controller to automatically switch the heating on or do manual overide, the Hotwater Controller shows the heating system to be ON, the pump either starts for a short period (say 10 mins) and then stop or the pump does not start at all. The Central Heating...