Recent content by furpho

In the end i cut out the channel and used expanding foam to stick in a new piece of board and hold the flapping sides. Worked a treat. All solid. Thanks for your assistance guys

Evening Ken.. very good point about the flapping. I think I’m going to have to cut the channel and see what I find. I’m now wondering about expanding foam board adhesive. I’ve never seen it used but if it’s similar to expanding foam it could stop the flapping and fill the gap. Not sure...

I’m cutting out a 6” channel from ceiling to floor in insulated plasterboard for heating pipes. If I then fill with expanding foam can I just cut it back and skim the whole wall?

Comprehensive information on all aspects of my issue. Feel like I understand what I’m dealing with now. This is a great resource and much appreciated

Sounds like sound advice. I’ll see what I can do to get some more bonding. Thank you for taking the time

Thanks Bonni.

Hi, normally I would fashion a board or two to fit in here or entirely fill with bonding. In the current situation i haven’t got enough of either. If I fill 70% with a couple of pieces of board and fill in the gaps with bonding will it crack later. I have plenty of multifinish

Yes it definitely helps to have another opinion and it all makes good sense. Feeling much happier about this now. Thanks Johnny

Thanks Woody. The door is external but you’re right the alignment is fine and door opens without issue. Much appreciated.

Hi, i bought this 1940's bungalow 5 years ago and fully skimmed after refurb. Unfortunately the plaster has blown in a few places which I accept for such an old house. My concern is the crack in the bricks above the middle of the door. The bungalow has a kingspost truss resting immediately...

All cabling is new. I never realised I should square off the edges before bonding. Thanks I’m comfortable with the skimming but I’ve forgotten a lot of the prep side. Never did a lot of bonding etc. If you’re talking about the far right corner on the wall with the socket below it is actually...

Thanks Alastair but with things as they are I’m going to have to use the bonding I already have so still need advice on best way to apply bonding

Hi. I need to build up a level on an existing plastered and emulsioned wall. The white area in photo. Only about 3 or 4mm. Do I pva before bonding? Do I score the wall? Also do I need to pva where I’ve ‘dug out’ some cracks.

Hi, what to do about the joint with the ceiling when replacing wall plasterboards and skimming. The ceiling is enormous so I won’t be re-skimming that. If I don’t do anything I’m going to see cracks. Coving isn’t an option

God I hope you’re kidding!! I’m confident but it’s still a big task for an amateur. Drinking tea and giving it a long hard stare