Recent content by Gerry Sweeney

Hi GalaxyGuy Thanks for the response. Its a shame, it seems like such an obvious thing. The Galaxy G3 hardware architecture is really very nice, it seems so well designed, but from a software/configurability point of view, these little touches are so important, and my current Menvier TS900...

Hi Alan, Thanks for the suggestion, unfortunately, that's a completely different menu on mine. I found this one Engineer -> 51 -> 59 Part Tone which I have set to Disabled but that makes no difference either. Gerry

Hi, Does anyone know if it's possible to make the "part set" function "silent" apart from the final two beeps? I am migrating from a Menvier panel which has options to program the part (night) set to be silent apart from the three short confirmation beeps at the end once set. This is very...

@GalaxyGuy ok don't worry I found the answer. The +LINE FAILCOM 1 relates to a tamper condition raised because there is no telephone line connected to the onboard TELECOM module. When you reset the panel to factory default, the panel is set to tamper based on the line failure on the module...

@GalaxyGuy Just to let you know that the PF RESET cleared once I added a battery, sort of obvious really. Can I ask one other question? I now get a +LINE FAILCOM 1 error, which I presume relates to the built-in telecom module (which I do not have connected), I presume (I am hoping) there...

Thanks @GalaxyGuy Yes, I will try the battery, that's the next logical thing. Where would one obtain the "Honeywell SPI key"? or indeed the firmware file if I were to update the firmware over RS232? Gerry

I forgot to mention, "using default UK settings" I should have mentioned, yes, using default UK settings, having reset to factory, it boots up and shows configuring UK on the menu so I presume that's what you mean. Gerry

Thank You GalaxyGuy, Yeah, it's not clearing, or it is sometimes, but it comes back. Well I did buy it on eBay so yeah, maybe a faulty one, it came without a case, just PCB and Transformer, so could well be faulty :( I actually don't have a battery connected to the panel so maybe that's...

I have now got a G 3-520 panel, the prox reader now works. Gerry

Hi, Having tried to commission a 3-530 panel (firmware 6.7) on the bench, everything is ok but the keypad beeps about once every 25 seconds. When I connect to the panel via GX Remote Control App and the Ethernet 080-8 module on my local network, it logs in OK, but tells me PF RESET REQUIRED I...

Hi GalaxyGuy No, I checked that, I have reset the Manager code at slot 18, it was set to 1234 now set to 1111, it's the same. I can only conclude the panel is too old, I am going to try to get a newer panel, something like a G3-520, this panel is clearly very old, almost 20 years old so...

Hi Galaxy Guy, Yeah I checked diagnostics as you suggest I only get 4 options 1=MEMORY TEST 2=KEYPAD COMMS 3=RIO COMS 4=PSU COMMS I can only get to menu 42 through the engineer code. When I enter the manager code (default 1234) I only see what I think is a short menu. When I go to 8 CODES, I...

Hi, I have a Galaxy G18 V2.31 ADT firmware and a CP038 keypad which has a Prox reader built into it. Does this panel support prox keys for setting/unsetting. I cannot seem to find a way of programming the prox keys. Any expert out there? Thanks, Gerry