got afew rads that i cannot get a grip on with a rad bleed key any ideas how to get round this problem,i was thinking a very small socket????might have to to stick a small bit of metal in socket to get a grip,need help asap please :!: :!:
Can anybody advise please I have old half inch steel water pipe running through my house from the mains stop cock as far as the kitchen which is in the process of being replaced.I have fitted a brass half inch compression fitting into the old steel pipe off one of the old elbows and run new...
got to t off some pipe under the floor for a new rad I never soldered any pipe before so will be using pushfit I normally use jg speedfit but what is better hep 2o 0r jg or copper pushfits
got to fit a radiator in a kitchen diner,my only problem is what size rad I would prefer to go for the 600x1600 double but its quite close to my free standing fridge freezer unless I pull the freezer away from the wall a foot or so or go for the 600x1400 double rad??the room now having been...
Hi I got a couple of rads that where the bleed nipples have rounded abit so cannot get a good fit with the bleed key, anybody know what size socket could be used to hopefully undo these little bliters and let me bleed them and hopefully get a replacement screw
can anybody tell me if a 700x1200 compact double convector radiator
the output is 8218 BTU 2407w
would give out enough heat for a room approx. 3.5mx3.5
anybody know best size panels to use next to appliances that don't have a carcase ie just have a appliance door on them,and how many you will need I have a washing machine,dishwasher and under counter fridge???
after my sink unit I will have a intergrated dishwaser no unit for this just a door front then running the opposte direction will be a corner unit which is underneath the breakfast bar,so what iam getting at is where the dishwaser ends next to the corner unit will I fit the corner post to the...
hi I have question with regards cornerposts in kitchen, if I have a highline corner base unit and next to it running off is my washing machine which is a built in type which will have a appliance door fitted but does not need a carcase will I need a corner post ??as iam about to order the units...
I am about to order a kitchen but not sure about a few things,i want to make sure my wall units next to my free standing cooker are inline with my base units(does that make sense)I am going to have a 900mm corner base unit with a 400mm door the corner wall unit above is 600mm and a 400 mm...
Got change my plumbing on my cold feed to plastic pipe I see they do a adapter for 15mm to half inch if I screw the adapter in to the old steel pipe can the plastic be pushed in to thenew fitting or should I put a small ppiece of copper in first and then add a coupling then the plastic???