Recent content by gjacques

I hope its not you i fall on when i tumble from my ladders!! :wink:

Hi, Yes its ipx4 rated which is slash proof, which is ok as its going in an outbuilding. Link shows actual unit. http://www.airtreatment.co.uk/index.php?main_page=product_info&cPath=24_30&products_id=224

I am wanting to install an outside heater on an wall of my property, the heater is 13amp and plugs straight in. Problem is i dont have a socket on that wall, i was thinking of putting a whole new lenght of flex on the heater and clipping it through to the nearest socket. It will need about an...

Hi, I want to fit a new upvc door, problem is there is a strange shaped top light above the original door. It will cost quite alot to get one made up so i was wondering if i could just cut out the wooden frame where the door frame meets the top light on both sides. By doing this i would be...

It was done to a livable standard upto a few months ago but i am suspecting the tanking was not done properly. The bubbling plaster is from floor level upto half way up the wall, its strange because its not an outside wall its a dividing wall between a bathroom and bedroom?? No other walls are...

Thanks, So i suppose any fix would be a short term one until the problem came back?? Surly there must be something i could do?

Hi, I have a converted cellar that has a wall where the plaster has bubbled up quite badly, would it be ok to board over it and skim?? I would very much like to find out why this started so that i can fix it. Any suggestions would be great Thanks

Pulled my double gas oven out today and its connected using a rubber pipe. The oven is a built in fixed type and i was wondering if this rubber gas connection is ok?? Thanks :?:

I have a cast iron downpipe that has cracked on the lower sections, is it possibe to cut the pipe down with a grinder and then attach plastic downpipe. Is there an adaptor available to connect plastic downpipe to cast iron, i dont really want to replace the whole lot as the top section is in...

Rather that putting a double socket on the wall would it be ok with a 13amp switch socket instead? Had someone over today saying it would be a bit safer incase anyone decided to plug anything else in the socket like the washing machine. To be honest think i will go with this option as i...

Just to clear things up, fuse on cons unit is a 30amp re-wireable type and its a single fan assisted oven. We like to say coooooker in yorkshire me lad. Thanks

Thought so!! Stick to original plan i think, and use an extension cable for the washing machine to ring main socket. Dont want to use extension cable but my only option in think. Thanks for all your help.

Thanks for your help Garrymo. One other question if i were to use one of these double sockets for a washing machine instead of the hob ignition would it still be ok or should i stick to the original plan?? :?:

6amp Breaker??? :shock:

I have a new electric cooker with a 13amp rating that can be plugged stright in and a gas hob that needs plugging in for its ignition. I have seperate cooker socket fed from a 30amp fuse with 6mm cable will it be ok to swap this cooker socket for a double socket and plug both electric oven and...