Recent content by golffury

Thanks for the reply, thought it was worth asking just in case.

hi, can I put up insulating lining paper and then put the coving on top of lining paper to improve the look?

Thanks for replying, I wasn’t sure if I could cross over them.

hello, I’m installing a new water main into my house as I have replumbed the place. The new line is entering the house at a different location and will be crossing my main electrical supply. The electric cable is 750mm below ground level which is the minimum depth for my water main. I...

I am running a remote fire valve under my lounge floor to the kitchen alongside the pvc covered copper pipe carrying the oil. Does the sensor cable need to be covered/protected or can it left exposed? Thanks.

Thank you all so much for your advice.

Only found 1 internal spring on Amazon and it was rated 1 star and the buyer said it wouldn't fit.

Thanks a lot, you've saved me from buying another set of pipe benders.

Hi, I need to bend 10mm pvc coated copper pipe. With the pvc coating the O/D is about 14mm so the pipe won't fit in the mini pipe bender I bought. Will I be able to bend the pipe in a 15mm pipe bender? Thanks.

Hi, Can any one tell me the best and most permanant way to connect a 2" solvent pipe to a 40mm solvent pipe? I have a kitchen macerator unit connected to a heavy duty non return valve. At present I am using flexible rubber connectors and hose clips but you can see them expanding and contracting...

Thanks for the advice.

Hi, This is my first time on this forum so please forgive any mistakes. I have just installed a sanisplit 3 which will be used to pump kitchen waste around 5 metres vertically into my loft then over to my downpipe. I have tested it using clean water from the sink and the problem is once the...