Recent content by groovybug

@jj4091 So, for low speed, I've got 35 Ohm and for high speed, I've got over 100 Ohm. I remember both the wires from power cable is doubled up, on the same spot with some other wires though.

@jj4091 I do have a multimeter, I dont really know how to use it. How should I test it?

it is Haag/Maan cooker hood, a couple of years old. I'm not sure if that will be helpful https://maan.pl/en/produkt/mix-3-60/

Hi everyone, Doing the stupid thing as usual, disconnecting cable without taking photos, and now I'm not sure how to reconnect the power supply cable. In the photo, the 4 upper wires is from the fan and the 4 lower wires is from the fan speed/lighting control unit. Thanks for your help!

@RandomGrinch I have reconnected into terminal 4, however the programmers still could not activate the boiler for heating. Do you think the problem could be in the splitter thingy, or the wire is loose inside the power unit?

@RandomGrinch Thank you. Do you mean, it is rough because it is not properly wired originally? Might I as well rewire the whole thing?

Hi everyone, My wife accidentally pulled off one of the cable connecting to the Danfoss programmer, and now the central heating does not turn on (hot water still working). Now I'm not sure how to reconnect this wire back on. Thanks for your help.

Yes, that's what I need. What do you mean by wetting agent though? Do I mix washing up liquid with the Milton fluid? And do these moulds present any long term damage to the timber? I have been so worried :(

Thank you. Do they come in industrial spray canister (like what they use in hospital)? As I have a big but very low and awkward loft to do.

Hi all, Like many of us, I topped up insulation on the loft at the beginning of winter. Unfortunately I committed the cardinal sin of blocking the eves, resulting in severe condensation and mould growth before I realised it. I have cleared up the airways, install lap vents. I have also run...

Hi Datarebal, Yes the asphalt is dressed about 15cm up the wall. But the bond is so strong, when the asphalt shrank, it broke up the brick as you can see. The pointing itself is not deteriorating, but the crack is more due to the movement of the asphalt (I think).

Hi all, I have these horizontal asphalt valley that runs on the two side of my roof. The valley itself is in good condition, however the joint with the parapet brick wall has cracked and the asphalt has pulled back a little. This has lead to some small leak down the parapet wall onto the...

Hi everyone, In my kitchen I have spot lights over the cooking area and a pendant light over the breakfast table that share the same switch. I want to split this out into two separate switches. I can access the lighting circuit easily on the loft, but when I try to thread another cable down, it...

Hi everyone, Not quite sure where to place this question, I hope it goes with the general bathroom/kitchen questions in here, but if not please help me move it to the right place. I'm looking to install extractor fans for bathroom and kitchen. What are your recommendation for one that doesn't...