Recent content by Grover2000

Can someone advise on a good alarm that can be used in my garage which is located opposite my house (It has power)? Some thieving bar-steward broke into it and made off with my stuff. Any help is greatly appreciated Grover

Hi the link suggested does not have the brushes listed. The motor type is P55TF Could some one advise on the brush part numbers for the washing machine? Thank in advance Grover

Great thanks for the advice. I will get them replaced. I noticed on Hoover's website there is multiple types, any indication of part numbers which are attached to my washer? Thanks in advance Grover

Hi can any one advise on the possible fault on my Hoover washing machine OPH714DS - 80. It is about 3 years old and has developed a fault. When the machine programme is set it comes on and seems to go through the motions of the programme but without the motor running to turn the drum. I...

Thanks Johnmelad, I have sent the company an email to match it, unfortunately there is nothing etched in the glass for me to forward. Fingers crossed they find a match. Grover

Hi does anyone has any experience of replacing shower rollers? I have attached the present one but it is broken and I need to source replacements. Any help on this issue is greatly appreciated. Grover

Hi I have the Stoves g550 with a few issues. 1 When the glass lid is closed one of the hob buttons don't self close 2 The fan stays on all the time Has anyone else had the same problems and how to cure them? Any help on the matter is greatly appreciated Grover

Hi can anyone advise how to diagnose the fault on my alarm. After testing the panic scenario by pressing 3 and 9 together I noticed that the alarm external Bell only sounds for about 3 seconds whilst internal sounder sounds until the panel is reset. Any help on the matter is greatly...

All Hail the power of Tony, I thank you praise be with the Biasi Master guru, the savior for Biasi boilers. Sorry, but this mistake resides with me. I removed the guide bush to make sure the stem was free from dirt again and wired the switch by mistake. Thank you once again Grover

Current state boiler is not showing any diagnostic errors. DHW/CH on the boiler tries to fireup but doesn't. Pump running throughout fan tries to kick in and stops Hence no fireup. Remove the pump connector an immediately boiler firesup. Plug the pump back in and the boiler goes to earlier...

Weird I know. But fires up fine without any hesitation what so ever Grover