Recent content by Guzzles

Only problem is they are from New Zealand - shipping will be a bit expensive! - How did you find them?

Hi , has anyone got any suggestions of how I can match some existing slabs? They are quite unusual - a natural pebble finish. They are at least 15 years old and are 40cm Square. Are there any websites, or suppliers of old slabs? Any suggestions gratefully received as I don't want to replace...

I contacted Ultra and they sent out an engineer. Apparently the mixer mechanism was broken - replaced for free under 10 year warranty - excellent service :D

Hi, I have a bath/shower mixer (one from ultra-group). It has two taps on it one feeding the shower, the other for the bath - plus a separate temperature control. The problem I have is that the unit only provides really low flow on the hot water - it works fine with the cold. I initially...

Okay, say the screen works out to be 50mm deep, and I removed this. If I buy top spec insulation board, and add UFH on top, do I need to add a screed layer ontop of that before the tiles, or is there a better way (considering I don't want it to be too deep). Is there a production where you...

I guess I need to see how deep it is by doing a test site. How easy is it to remove the screed, is like sh*t to a blanket, or does it crumble after a small amount if abuse?

Our kitchen floor is a block & beam floor built in 1989. I would ideally like to install underfloor heating (UFH),and I was wondering whether I could: 1. Lift the screed base 2. Install insulation boards 3. Install UFH pipes 4. Tile This would mean the floor height would still be around...

Hi All, my mate has had problems with his Glow Worm Boiler. I'm unsure of the model number at this stage, but it is only about 5 years old. Initially the PCB blew up, which was replaced ok. What he did notice a little while later was water near the PCB. Its only a small leak/weap, but it...

Hi DH2, the problems you are experiencing sound familiar to my situation. I have the Ecotec618, VR65 and VRC430. The instructions are poor and the support from Vaillant is just as bad. I think the units are quite complex, and can probably perform really well, but unless they are setup...

The product your after is Magnaclean http://www.adeysolutions.co.uk/?gclid=CNHvpsvRiJYCFROA1QodoFLLEQ . Have a search on the forum, there are plenty of discussions on the product. I've got one on my ecoTEC 618 and its fine (at the moment).

I have spoken to Vaillant again today about this issue. The chap (Jaz) who I spoke to was a lot more helpful than the previous bloke. He was still struggling a bit with the manual and agreed that there was important information missing. He has sent me a 'easy guide' which might help (can't...