Recent content by heatingengineer

any one got some good ideas??

whats the cc??

having a problem with this boiler.. the fan sometimes pulsates on and off when it does work the temp goes to about 60 deg then falls down to 25deg. any ideas ??? i have checked the air pressure switch it seems to be working when a checked it with the muiltimeter, when its on it modulates no...

240v was on the switch live on boiler term strip, my mistake all the wiring was correct the fault lay on the p.c.b. i dont understand why there are so many pri cks on this site do you????????????

well guys it was the p.c.b that was at fault......... cheers

Why was the fan fitted? Also where is the blr location, just to rule out frost stat. Why are manuf instru wrong according to your S-Plan knowledge? the wiring is wrong according to the instruction!!!!

the fan wound its self and was stuck solid

boiler is in upstairs cupboard next to the sealed cylinder. it can realy only be the p.c.b then. tryed for hours to get through to vokera managed to get throgh once after 40 min then the **** hung up when a told him the fault. just for you dp lower case, take a chill pill if thats gettin...

NOPE NO FROST STAT AS STATED ABOVE 2 ZONE VALVES AND CYLINDER STAT, THATS IT. CHECKED ALL THEM OUT THEY ARE WORKING CORRECTLY- NEW FAN FITTED ON WED CUST SAID PROBLEM HAS BEEN SINCE THEN WHICH I DONT BELIEVE THE WIRING AT THE JUNCTION BOX- ISNT WIRED AS PER MANUFAC INSTRU- BUT IS WORKING...

PROBLEM IS WHEN THE SELECTOR SWITCH IS AT THE OFF POSITION THE BOILER IS STILL ON THE ONLY WAY TO PUT THE BOILER OFF IS PUTTING THE SELECTOR SWITCH TO RESET. I HAVE CHECKED FOR THE END SWITCHES IN ZONE VALES THEY ARE FINE AND THE CYLINDER STAT IS FINE. THERE ISNT ANY ROOM STAT. ALSO THE...

thanks very much

a think the pump may have been running

there is a by-pass under boiler half open, the domestic side must be gettin a feed 2 the heating side somewhere surely?? any other things i could try?

radiators heating up stairs when running hot tap, also hot water temp scorching hot, checked flow rate and burner pressure all correct, has this boiler got a diverter vale or is it through the heat exchanger? maybe has pin hole. pressure not going up staying at 2bar. glow worm tech...

all say for this site is that its mostly arseholes like fazedup who are on it and for the parts we cover the boiler so the cutomer want have to fork out anything, out of all the repairs the company has done this has been the worst case we have came across, thats why we called vokera not much...