Recent content by Heyyouitsme

does everything work, lights, heated rear windows ect, sounds like you have something drianing the batetry, are the wires on the alternator ok, and the wires to the batetry not rubbed thru?

clutch should take no more than 2 hrs max, but thats providing they have the aprts and they can fiut you in right away, an no more than an hr for an altrnator id say.

needs a new alternator

how did u get on?

already told him this davie in the previous post, he ignored me

check all the little tiny rubber pipes that are on the top of the engine, i bet it s the vac sensor for the top of the engine, if the pipe is split or not connected or the vac sensor is dodgy it will overfuel and run lumpy

to have tracking done properly it should take about an hr, 50 is about the hourly rate, libby you may not have needed anythng doing hence it was just a check and no correction, ians is obviously out

hi yeah whats the diff between carpet and wood, i really confussed ;)

think u shud have used that solution in the 1st place, the fact it contains bleach will not change the colur back to white. the fact is the white colour has now been tainted yellow by chemical reaction (with the bleach)

dnt forget to use unibond either, otherwise you will have to put about 100 coats on as the new plaster absorbs the paint

think he means somehting more along the lines of it wnt damage the element john. Plus if my self cleaning elec oven is anything to go by it takes forever for the gunk to burn off the element, resulting in a smokey kitchen lol

yep, would have to agree, sounds like the alternator, check the neg lead on it also, renults are notorious for this fault

i would bet my life its your top dead sensor, its located at the top of the bellhousing (where the gearbox bolts to the side if the engine) think its on the right hand side as you look at it, its held in with x2 10mm bolts, a semicircle piece of metal with a thing about 30mm coming down off it...

you have to remove the plenium (top of the engine) the airfilter housing from the side and the manifold from the front of engine, as the throttle bod is inside this.should take bout 2hrs to strip, 10mins to clean an 2hrs to reassemble

tis a mark 2, the new ones are a 3. as for the clock, ahve u tried scrolling thru the computer options, there is a button at the end of one of the stalks on the steering column you could remove the steering wheel and put it back central, but the real problem is the tracking is out, take it...