Recent content by Hoppo1234

That worked . Many thanks for all of the advice received.

I've tried a number of things, including reprogramming, so switching the doors off, but there is no difference. As soon as I arm the alarm, it just shows 'area in exit A'. The walk test is ok, and all are registering. Photo attached.

Hi, thanks for your help. I've changed all of the zones to TEOL, and they are now registering on the walk test. The alarm, though, will still not set and is still emitting a loud continuous noise. The doors have Verita Impaq E AEA-0001, which are set to be normally closed. Could this be the...

White and green are wired back the panel, i wlll give the programming a try. Many thanks for your reply.

I've decided to reset it at the panel and start the programming again from scratch. This is a photo of the wiring in the PIR.

Image from instructiion manual

Ive attached phots of the PIRs, they are a mixture of AFA-0001 and AFB-001. Is the wiring the problem and should I also wire the t-EOL back to the main board

Hi again, ive just tried to part arm, and it makes the same noise for about 10 seconds, then arms; however, the PIRS dont trigger.

Hi there are 4 wires. Timed exit i believe

Hi, I've just fitted a Texecom Premier Elite 24, and I have a problem. Ive got power to the PIRs etc but when I perform a walk test, the screen shows 'none' and doesn't react. The PIRs are a mixture of AFB 0001 and AFA 0001. The PIRs light up and they are all set to zone A. The other issue...