Texecom Premier Elite 24

[Hoppo1234]

Hi, I've just fitted a Texecom Premier Elite 24, and I have a problem. Ive got power to the PIRs etc but when I perform a walk test, the screen shows 'none' and doesn't react. The PIRs are a mixture of AFB 0001 and AFA 0001. The PIRs light up and they are all set to zone A. The other issue is when I try to set the system, I get a loud continuous noise, and the screen shows 'area in exit A'. I've tried switching all of the PIRs to out of use on the system thinking there is a problem with the PIRs, but still no change. Any help please?

 

[sparkymarka]

How are the PIRS wired ? 4 wire or end of line ? Also is the setting set to final exit or timed ?

 

[Hoppo1234]

Hi there are 4 wires. Timed exit i believe

 

[Hoppo1234]

Hi again, ive just tried to part arm, and it makes the same noise for about 10 seconds, then arms; however, the PIRS dont trigger.

 

[sparkymarka]

Post pictures of wiring in control panel and the detector …

 

[sparkymarka]

At a guess it’s not programmed for timed exit …

 

[secureiam]

not walking testing ?

any errors in day mode?

Have the zones in use been programmed correctly or not at all?

at default the arming mode is E/E this requires the the e/e zone to active and then secured, this should be a door contact and usually on zone 1.

 

[Hoppo1234]

Ive attached phots of the PIRs, they are a mixture of AFA-0001 and AFB-001. Is the wiring the problem and should I also wire the t-EOL back to the main board

 

[Hoppo1234]

Image from instructiion manual

 

[secureiam]

Programming is TEOL. For the anti masking although unless there is a fault it will work on double pole just won’t report correctly.

Can’t see the wiring so clearly on my phone where I am now.

Withe lid secured properly. What’s is saying in zone status ?

 

[Hoppo1234]

I've decided to reset it at the panel and start the programming again from scratch. This is a photo of the wiring in the PIR.

 

[secureiam]

white and green back at the zone.

zone programming needs checking and wiring type set to TEOL

 

[Hoppo1234]

White and green are wired back the panel, i wlll give the programming a try. Many thanks for your reply.