Recent content by hotnuts21

OK cheers will have a look. The compression fitting on the sink waste goes on nicely so I think thats a 40mm, and the shower waste is a 50mm which is why its loose on the pipe. I will see what the plumb center has in the morning.

I've got existing 36mm waste which I can't replace and I want to join a new shower waste into it. I've looked but I'm well confused, the compression fitting should apparently take the solvent weld but the washer is too big. Is there a reducer I can screw onto the shower waste (40mm??) That has...

Hi all, Im going to batten out my external wall and fit Kingspan K18 to insulate the external wall. However the wall is 3.7m long by 2.5 high. 10cm bigger than a 2.4x1.2 board vertical or two boards horizontal across the battens. Now the manufactuerers recommend leaving a small gap at...

erm there is no header tank, its an integrated cylinder its got the cold water store built in. Will that still cause a problem? The tank is only moving 1.5m higher than it is now. pictures are decieving, there's tons of headroom in the loft.

Pics attached this time :-)

HI all, Im going to rent my spare room and to make the airing cupboard into a wardrobe. This mean the hot water cyclinder needs to go in the loft. The Cylinder is a integrated type(with a built in header tank), made of copper and its about 90cm high so not huge. Im going to prepare all the...