Recent content by IHGMay

@JobAndKnock thanks, I've found some of these trays online following your advice. Debating now whether I need a drain in it or not, as I'm not so keen on cutting into the existing pipe that proved to be working well...

You were right, I managed to get by with the old one though, it just required more pressure and patience It was a wood only blade but the teeth were worn out a bit. I managed to do it in the end with that blade. Time to get a new one now as I ran into a couple of nails along the way

The one that I have cuts the real wood easily but doesn't go through this material. Just wondering if the new one is going to make a difference..? I know it's nails, so I'm not trying to cut it off the wall, but rather trying to cut in a few smaller pieces to deal with them separately. The...

Wooden joists under the floorboards. One floor below there is kitchen with a boiler in the corner. I want them to reinforce the floor as well just in case as I'm going to stack a dryer on top of the washing machine – a bit concerned about the total load right above the boiler.

I need to remove a skirting board without damaging the new plaster above it (should have done that beforehand really, I know), so I thought I would just cut it into small pieces and remove them one by one, but my Erbauer multitool wood blade can't cut deeper than the outer layer of this...

I will have the builders soon replacing floorboards with plywood and laying engineered wood on top. The washing machine will be concealed in a corner cupboard with a row of built-in Ikea Pax wardrobes right next to it along the wall. What is the best way to isolate the washing machine, so that...