Recent content by Infinity

  1. I

    Grass issues

    Thanks for the advice , I'll check it out.
  2. I

    Grass issues

    Thanks Old Salt
  3. I

    Grass issues

    Hi, I've noticed some cracks appearing in my lawn and also so dark thick grass patches. Please can someone tell me how I can fix the cracks and get rid of thick patches. Thanks
  4. I

    How do I take this off?

    Thanks for your support and help, really appreciated. Manged to take the old one off with the tool from Screwfix and replaced it with a new one, No more leaks !
  5. I

    How do I take this off?

    Thanks all for your help. Its seems easy enough to take off with the right tool. ive seen a set on Amazon!
  6. I

    How do I take this off?

    Hi, I have a leak on the push fit elbow joint under my sink for my outside tap. Any ideas how to take it off? Is it east to replace with a push fit for. Screwfix!? Thanks Sid
  7. I

    Pyronix Dual Tech PIR changed battery nor saying restore required

    Check the back and the metal lever is there.
  8. I

    Pyronix Dual Tech PIR changed battery nor saying restore required

    It's definitely on as checked it clicked when I pressed it. I'll take it apart and try again. Thanks
  9. I

    Pyronix Dual Tech PIR changed battery nor saying restore required

    Hi, I've just changed the 2 batteries on a Pyronix Dual Tech PIR using the engineers' code, but I now get a restore required. I've tried pressing A and exiting but still no luck. I've re-opened the PIR to close it again making sure the tmaper switch is pressed but still no luck. I've just cheled...
  10. I

    Pyronix Set B disarm delay issues

    Thanks for your help. I programmed a keybob to make it easier to arm and disarm zone B from upstairs without using the keypad! But I still have a slight problem. When arming zone B the keypad flashes and the redish B button lights up but there is no sound. Sometime back it used to beep when...
  11. I

    Pyronix Set B disarm delay issues

    I'll look through the manual and check -thanks
  12. I

    Pyronix Set B disarm delay issues

    No other device. There is only 1 pir near the stairs.
  13. I

    Pyronix Set B disarm delay issues

    Yes I have the engineer code. I've not set the alarm on zone B for some and only tried it yesterday, but we did have an engineer in to reduce the loudness of the beeps a few months back who might have made a change. My fault for not testing it after he left.
  14. I

    Pyronix Set B disarm delay issues

    Hi All, I have a Pyronix Enforcer Alarm and it worked fine until recently. When I use to set B zone for night time the alarm sets fine and I was able go downstairs and the keypad would flash and beep giving me a little bit of time to enter my code in the keypad to disarm the alarm, but...
  15. I

    Garage door insulation and ventilation

    The main concern is the vents in the door, can I cover them or should I leave them to allow air to circulate?
See more
Back
Top