Recent content by Irnbru72

When I laid my engineered oak over my floorboards I just put sheets of plywood down as my floor was all over the place, made it slightly more level, I then put down the green underlay boards, then the engineered oak. I'm sure it would be fine to leave the hardwood boards and then the underlay...

Thanks Pinenot, I'll buy some Oxalic acid to remove the black water marks before I start. Cheers

Hi guys, I'm about to re oil my ikea beach work tops but there are a few cracks near to the taps in the work top. I've no idea how to repair them before I oil the work tops again. I usually use ikea oil but reading another thread it look like Oslo work top oil is the way to go so think...

Thanks for the reply and advice PVMS, the brackets you posted look a good bet, I can cut or chisel a few mm off the battens too but think ill order some of them brackets as well. The guy who made them dropped me down extra battens incase I wanted to fill the gaps and screw straight into the...

//www.diynot.com/network/Irnbru72/albums/ Ive added a couple more pics of the fence panel and battens

Hi thanks for the response. There 7 ft for sure,, just my luck, lol in order to keep the small concrete posts I had to have them made 7 ft wide, they only make them in feather edge so went with that, there not triangular there square battens, the guy just gave me some clips but they are not...

Hi guys, could anyone offer some advice replacing my garden fence? I alreadt have small concrete post which are bolted to wooden posts and have 7ft wide panels. I have had 7ft wide by 5 ft high feather edged panels made, and ordered 3x3 inch fence posts. Whats the best way to erect the fence...

Garden fencing

//www.diynot.com/network/Irnbru72/albums/ Hope ive uploaded the pics correctly guys, btw sorry for spelling errors im on my phone