no drain valve on the boiler either.
I've left the boiler/heating off for an hour or so and when i turned it all back on again, the boiler fired up, started heating and after a few minutes the overheat switch popped out and the boiler shut down :(
Rang EON and they will be out Sunday (£50...
there is what looks like a drain tap in the airing cupboard. It looks like it comes off the immersion tank; all other pipework is hidden.
(the boiler powers the central heating and the immersion tank powers our hot water; not a combi system).
OK, i googled "drain tap" and none of the rads have this on. They are Danfoss radiators.
As for post above - i am with EON heating plan. I'll give them a call in the morning if i can't sort it tonight.
Thanks for all the replies.
it's strange that all i did was bleed the one radiator (everything was working fine before this) and now none of the rads work and the boiler is cutting out.
Hey all,
I think i have knackered my boiler / radiators and could do with some help!
The boiler is a Gloworm ultimate - i do not know the model number as i can't see anything written on the boiler and the last occupants haven't left us any manuals! The bottom tray slides out for the...
I have a Zanussi zwf 1621w and when it is finished its wash we get 2 x beeps and some of the water isn't drained.
A check of the manual indicates that the pump may be blocked (2 x beep error code).
The manual says in the bottom right corner of the machine, open the service flap...
OK, 3 cables come from the flex - blue and earth are connected to element and brown was connected to thermostat. Coming out from other side of thermostat was the white cable which again connects to the element.
When i removed the thermostat i undid the white and brown cable and the...
ok, i've took the thermostats out and now have 2 x BT7 thermostats. On the net i have found these:
http://www.theelectricalcompany.co.uk/search.php?xSearch=bt7
Are these OK to use? Or can anyone recommend a better one?
Also, when i took them out, there were 2 wires going into...
forget it. Spoke to the previous owner and apparently he left his coupling at the end of the pipe.
I undid the clip and the connector part fell out, leaving the correct part to connect to the waste trap.
:oops: :oops: :oops: