Recent content by Jakes

Activated float switch will do that. Sounds like the pipe is leaking and has filled the base.

Hi, there is a float switch in the base which activates when the machine floods the base. Not the base you can see when you open the door, but the base under it. There may be a little hose on the back with a stopper in it, if there is drain it out from there and try again with no content...

Hi, I am an ex AEG engineer (worked for Service Force as the under guarantee repairer for AEG) This is a bit of a tricky one without looking at it, you may be best calling an engineer. Normally AEG machines will wait upto 30mins for water to reach temperature and then will carry on...

Tockworth is probibly right, but thought I would add that it may be low water pressure. The valves use water pressure to stay closed (normall need 1 bar) If you have less than the required pressure the valve leak slowly.

Hi, before you do anything anyone suggest please do this. Start simple. Clean the soap draw, especially the conditioner section. If this blocks water can overflow the compartment during the rinse. It will track down the front of the machine, round the door and down on to the floor. Very hard to...

Hi, If the drain pipe is connected to the sink waste its possible that the machine is back filling with dirty water from the sink. That would explain the smell. This can be fixed by moving the drain pipe so it rises as close to the worktop as possible and then down into the sink waste spout...