Recent content by Jamespf1

they were walked on after 24hrs. Probably that that’s done it. Okay will slurry them down if any problems. Thanks

Hi all, First time laying Indian sandstone. Laid on a 4/1 mix of sharp sand. Semi wet mix. SBR and cement slurry on the bottoms. Laid on a 50mm full bed. Lifted one and can see that they have been laid perfectly on a full bed or mortar. After 48hrs the slabs have a slight hollow sound when...

Hi all, The DPC is 2 courses under the door. I want to do concrete steps up to the door threshold. So am thinking 2 steps needed. This would take me above the the DPC. What precautions would I need to take? Would I be okay to wrap DPC around the bricks where the concrete would go? And would I...

Hi all, The DPC is 2 courses under the door. I want to do concrete steps up to the door threshold. So am thinking 2 steps needed. This would take me above the the DPC. What precautions would I need to take? Would I be okay to wrap DPC around the bricks where the concrete would go? The steps...

Helpful

Hi all, I would like to have concealed hinges on my hidden door. It’s a standard bedroom door. If I was to use 4 kitchen cabinet hinges would this be strong enough to hold a door? I have loads of cabinet hinges left over from my kitchen refurb and the concealed ones are quite expensive. Thanks

Hi all, I would like to have concealed hinges on my hidden door. It’s a standard bedroom door. If I was to use 4 kitchen cabinet hinges would this be strong enough to hold a door? I have loads of cabinet hinges left over from my kitchen refurb and the concealed ones are quite expensive. Thanks

Hello, I will be laying engineer hardwood in a herringbone pattern. The flooring in engineered hardwood. It will be floating and with tounge and groove sections. Is it necessary to glue the tounge and groove sections? Thanks

Hello, I believe I have installed my aluminium window the wrong way round. I believe I have what was suppose to be the outside face on the inside. Is this going to be a problem with damp / rain? It’s a non opening window Thanks

Hello, Is there a product that I cause use to connect a clay airbrick to rigid ducting? There’s is a cavity wall as well. Need run ducting from existing air bricks on house through extension and into new extension brickwork. Thanks

Hello, I have quite a few 80mm gaps to fill in where LED spots lights use to be. Could I use plenty of scrim tape over these gaps then easy fill over them? I’m thinking the scrim mesh would be similar to drywall patches you can buy. Thinking this will be quicker to do then screw plasterboard...

Thankyou. In future for testing copper work with the filling loop on the boiler. Will this pressurise flow and return? Or would I still need to connect a F&R together? (Providing all rads are off)

It’s a mix. Does the boiler filling loop push waster through the flow and the return pipes? Or do I need to connect one of them together? Thanks

Hello, Going to give sand and cement screeding a go. Don’t think I’ve quite got the skills to build up my levels with screed around the perimeter and work of this for my levels. So would it be possible to set a timber batten around the perimeter for my level and work of this to get a flush...

Hello, Going to give sand and cement screeding a go. Don’t think I’ve quite got the skills to build up my levels with screed around the perimeter and work of this for my levels. So would it be possible to set a timber batten around the perimeter for my level and work of this to get a flush...