Recent content by jammers

Thank you - just what i was after.

Hi, I am building a shed with 2 leafs and need to put a mono pitch roof on it. I have attached a diagram, and basically want to know; Do i build up the outside in brick to meet the underside of the rafter or build up the centre insulation to the rafter and just close it in with sofit and...

Really I will check again, but on my one it didn't come up with buy or add to cart? Is that b and q or tradepoint?

Thanks Guys. Just counted the splines. theres 20 and the hex nut is 17mm. I see what you mean about Lunns - they are expensive!!

They aren't available anymore - if you notice there is no buy button

Hi Guys, I have this tap (link below). Before I take the cartridge out, I would like to have one ready to go in, but I can't determine what cartridge i need? It says its a 1/4 turn ceramic valve, but there seems to be different height etc. Can someone help please? Ta James...

whats the best way to deal with this would you say?

It looks like salts in a couple of the areas, it was previously tiled - would that have a bearing? Also, if its salts whats the cure? Thanks for all the replies ...

Thanks for replying. The plaster was dry, if I remember, I left it for a week or more before and used a breathable paint for all coats. It just seems bizarre in the places its breaking out in.?

Hi Guys, I have a sort of wall rash breaking out - thats about the best way to describe it. I have linked pictures to my drive, link here; https://photos.app.goo.gl/EPaPF4JTOJahsALB3 So, the area was re-plastered about 8 months ago and in the last 2 months all these patches have been appearing...

Hi All, I was just going to have my boiler (its a worcester danesmoor 15/19) replaced with a new efficient oil boiler (worcester xx). However because if the ever increasing cost of Oil, I thought I would research Air Source. My system runs off the worcester and I have a cylinder upstairs...