I've seen some websites that calculate this, I will check before actually buying
I've watched a few guides on youtube on installing the rail, making sure inhibitor is used after install etc...
I have a combi boiler & from the research I've done.... all you need to do is turn the boiler...
Not if I get this badboy.....
http://www.screwfix.com/p/kudox-curved-white-towel-radiator-1100-x-500mm-524w-1788btu/45438
Seriously then, is this really not a DIY job?
I want a rail that can hold more than one towel. I know I can get a normal wall rail but I've got a very small bathroom & it'll be too much going on. A decent rail will cost around £50+, so I might as well get a nice heated one!?
I'm pretty sure I'll be able to plumb it in, the filling &...
surley its just a bit of filling & drilling some holes? If I find out exactly how to drain the system, I'll be ok?
How much would a plumber charge for this anyway?
Thanks for the replies!
So this is what I'm going to do (step by step, I like to make sure):
1. Empty the system.
Q: I have a sealed combi boiler, so how do I drain it, as there isn't a drain pipe on any of the radiators?
2. Remove radiator & take off the plastic pipe.
Q: Is the...
Hi,
I've decided to replace the radiator in my (smallish) bathroom with a heated towel rail.
I've found guides on the internet on how to install the rail but how would you guys tackle this?
Behind the radiator is one big hole where the pipes come out off. Now would you leave this &...
Thanks for the help, but I don't know even know what a spar is - so probably not wise to attempt this!
So I'm going to replace my radiator with a heated towel rail, as this should be much easier!?
Hi,
I'm thinking about installing an electric heated towel rail in my bathroom but just want to make sure it's a job I'll be able / know how to do .
Can anyone give me a quick guide? Also is it ok to tap into a plug socket outside the bathroom for powering the rail? ie.
Wiring
Towel...
I checked the wiring again....
Looked at every bulb & found 2 that were 20W!!!!
Put it all together again & to my pleasure....... switched on the lights & instant light!
Thanks for all your help!!!!
What is a Class II transformer? (don't know much about this stuff - thought it'll be a simple swap)?
Got the transformer off ebay - seems a good seller!?
Here's some pictures. It's a 10 arm lamp & all the bulbs I believe are 10w.
New transformer:
Old transformer:
Where would be the poor connection? I've made sure the connections to the transformer are good!?
Could it be the earth going to the actual fitting?[/img]