Recent content by Jay003

Thanks appreciated

Great thank you! Is there a particular thinner and sealer you use?

Hi! Hoping someone can confirm my approach to maintaining my printed concrete driveway. It’s probably 6 years old and is looking a little tired. I’m thinking to…. 1. Clear any pockets of weeds between cracks 2. Remove mastic 3. Pressure wash 4. Mastic between joints 4. Reseal I wasn’t too...

Hi. Hoping someone can advise me on how to resolve! My front driveway wall (between me and the neighbour) keeps on blistering and rusting. I’ve painted over and added anti rust solution on 2 separate occasions, but over time ends up back looking like the picture. Any advise is greatly...

Hi there. Hoping someone could give me some advise please. I’ve noticed below the sink, water pooling up in the cupboard located under the sink. Having looked at it whilst the tap is running I’ve located where it dripping from but no idea how to fix. I’ve taken a couple of pictures to illustrate...

Just a final one. On pressing down on some of the cracked areas on the wall does move a little. Wondering, should I be removing these loose bits (even if it creates a hole?)

Thanks Wayners, appreciate the advise!!

Hi. Hoping someone could give some advise please. have a number of corners in my house showing cracks. My plan of action is to use fibre tape and then filler before painting. Does that sound correct for the cracks I’m seeing? Also, around the bottom of my front door I’m seeing some gaps...

Hi. Yes he built it but I’m worried if I push too hard to underpin he’ll do a runner. I’ve asked before and I knew he was not keen at all. So I’ve opted for less expensive (For him) routes up to now

Hi all, wonder if anyone has any advise. I’ve been monitoring this crack for a few months now and has grown to what it is today. I had an outbuilding build Sept 2018 and since then I’ve had to repair the other side of the building by putting in an expansion joint to allow for wall movement...

Thanks foxhole. I’ve been monitoring it over the last month and now has grown to this. Do you think it’s worth monitoring yet further to see if continues to widen or simply go for the expansion joint now? Not sure what is the point of no return! Thanks

Great thanks for the responses. Sounds like a bigger job that I first thought but I’m keen to sort out so I’ll most likely use this time to do something productive. Thankd

Hi. My lawn is lower than the patio and is uneven/patchy. I’ve been thinking about raising the height (say up to 10-15cm in some places) and levelling out. not all that knowledgeable about how to do so. My first thought was top soil and dropping it over the grass over time. Not sure if that’s...

Hi. Doing a few repairs to some cracks in my external wall. Now that I’ve applied the filler I want to make the finish to match the existing wall (see picture). Any ideas on how to do? Could I do using a sponge to create the dash effect perhaps? Thanks

Hi. Spotted this crack to one of the external walls of an outbuilding that we’d had build a couple years back. We had an issue with one of the walls last year which is a single wall. For that the builder put in an expansion joint. Now I’ve spotted a crack of one of the double walls, I assume...