Recent content by jig

Hi Albert, Thanks for posting. I am cocerned as the feed does not have an earth would that be a prob?

Hi, I have just had halogen lighting fitted in a dining room but the wiring had red and black and no earth. The lights have been daisy chain connected, with transformers then connected to the light. There is no earth will this be a problem? Am I compliant? Do i need to rip the whole...

thanks so far guys, reviewing current suggestions, but still havent found the lever taps required :(

Thanks John, will take a look, im pretty shore the elbows need to be a certain length, bigger then the spout.. Bump!

Thanks, but I think he wants to get something similar but not as expensive. Just needs to have the elbow/wrist functionality, for hygiene reasons.

HI all, Trying to source some medical elbow taps (two seperate) or even a monobloc(will change the sink!), for a small bathroom type sing in a G.P's surgery. Does anyone know of any cheap supplier of these? Thanks Jig:)

Hi, I have taken away the carpet to our small room to reveal a nice hardwood t+g floor, which has some small gaps. I have teared away and sanded away at the artex from the ceiling. Unfortunately the white nasty pwder has fallen into the gaps, the floor has been moped but cant get rid of the...

I think your right I have to take the lamps off, the are attached to a small block of brick and sit on top, ie , marking the entrance to the driveway. I will try to take them off and see if I can add the connector. Also im I trying to fin the bayonet incorrectly, do I just feed the wire into...

Hi John, Whats an FCU? The plug has a fuse inside it which goes into the timer plug. Lamps are metal. I am struggling as to how I can connect the new brass abyonet fitting as this will screw on to the stem but the expose wires are just at the tip. Plus if I could reach or pull on them so I...

When I say old they are probably only 5 years old, so not antique! The wire goes straight up the (inside) brick work and throught the stem of the lamp, and currently i can see two copper cores at the tip of the stem which is the bottom of the lamp where the fitting attaches. There is no...

I have just tried to replace an old bayonet fitting for a new brass one. I managed to get the old tired rusted on off to find the wiring (which is like stiff copper wiring very short and impossible for me to wire into the new bayonet. How many wires should be there? I also noticed an exterior...

What is IP CCTV?Does it cost more?Does it require specialist cameras/equipment?

What are the Day/Night Cameras like? Do the LEDS fail after a while?Is it best to get a seperate IR Lamp? Who is best to buy from?(online/retail suppliers?) Thanks jig

Whereabouts are you based?I could give you the job? im looking to spend about £200 each on the cameras but do not need to be vandal prrof but waterproof. DVR seems expensive!(is there a cheaper option?) Cheers Jig

Hi Im hoping to get cctv installed. I am hoping to buy four external Day/night cameras and two internal cameras with DVR. What is the best make and model of cameras?Where is the best place to buy from? Thanks in advance for all help and advice Cheers Jig