Recent content by John£££

Handyman jo yes your right it defo helps but there is absolutely no mention of it in my manual (latest edition)

Greats worked a treat. I see the panel/keypad comes with 2k7 and 4k7 resistors but also came with 4 476ohm resistors what are they for

Sparky havin a problem changing the codes. I have changed the engineer code OK then in engineer menu changed master code not when I try to enter master menu It just sets the alarm how can I get into master menu to add user codes

Sparky... Thanks for all your help.... I'm such a dick. I've been pulling my hair out all morning trying to sort this out and eventually twigged on while the keypads were off I turned the display screw on the back which whited out the text I thought it was a volume adjustment pot needless to...

Sparky need your help on this 1. Have installed the euro mini with 2 keypads 1 would work the other just lit up with a blank screen. Now I programed all the inputs and addressed the 2st keypad couldn't get 2nd to work disconnect the 2nd restore power now the 1st kp won't do anything lit up with...

Thanks again Sparky

OK so board is scrap will the euro mini work direct with my 2 existing key pads pir detectors and Bell box or will I need to upgrade the whole system

Cheers

I see it's discontinued any recommendations on a direct replacement which will work with existing detectors

Sparky remove all and still the same keypad is dead green light on control panel getting power just not outputting 12v to any outputs at first I noticed when I would remove power and boot up the key pad would say v1. 1 with a few dashes lije it was booting up then it would flash of and on then...

Voltage is the same disconnected

Hi guys can anyone tell me if my panel is goosed or is it just a battery. Battery is dead but also is keypad only getting 200mv at aux or keypad terminals panel powers up 18v to terminals from trans but after a few minutes keypad dies totally blank. Will installing a new battery fix or is the...

Thanks sparky for all your help

On a side note the wireless bell box has 12v power in can this be connected back to the aux on the I/o board or say to a doorbell psu so the comfort leds can be run

Great help