Recent content by johnberman

Perfect thanks John B

Hi Im in rented accommodation and the bath has no shower curtain - I have asked the landlord if the bath could be moved at my expense - I got a no on that. So thoughts on a curtain would be appreciated - cant see a door working Picture below Regards John B

Hi I would like to replace some kitchen cupboard doors (the frames are good) I have looked around but can find the right size They are 495 x 675 A couple of pictures included Regards John B

Hi Can anyone recommend a canned spray paint that is suitable for Kitchen cupboard doors, draw fronts ? The doors are in a decent condition I just hate the brown colour and am looking to go a cream colour (nothing fancy like High Gloss) Regards John B

thanks for the feedback, its 1 \ 2 inch - i had a valve but it was the type that screwed in with no flange so was hard to tighten john b

Hi I have installed some radiators, they are the old school type. At the top I want to add a bleed valve, so I have put one in and used PTF tape on it etc, now I screwed it in but it leaks, if I screw it to far it will simply fall inside as there is nothing to stop it. Is there a special...

Please bear with me for the length and non-technical speak We have a Gravity fed system with a Glo worm Micron 50ff to provide hot and cold. So we have been away and its been off for a few months, powered it up and the hot water is fine, it heats up and when I run the hot I can hear the...

John Thanks for that, a larger hose is a thought, reading online it does seem that a pump would do the trick , i can see how they work and fitting actually does not seem to difficult - probably get 2 or 3 plumbers to quote and see what happens John B

Hi Thanks for the reply, Im not a plumber so forgive me if the terms I use are incorrect. Currently there is the hot and cold and they are 15mm going to the taps on the bath, and the shower screws on to the top of the taps. looking at the Mira it seems to need its own 2 pipes ? John B

So far this has cost me £60 for a plumber to say I need a pipe from the tank and then a further £360 to do the work (not bad for 2 hours work) and while I can mix the temperature properly the pressure is so poor its useless. Pointers appreciated. John B

err right, given where I am now what the suggestion ? John B

Hi So I have posted before with an issue because the shower which is attached to the main bath taps could not mix properly, apparently it was an uneven pressure issue - so a plumber has run a new feed fro the cold water from the tank in the attic (it was from the main before) and he charged...

Yes It mains pressure and so much more fierce than the hot, hence in the shower its like a competition and COLD WINS John B