Recent content by jpm777

It works! Thanks everyone for their help.

Thanks for the comprehensive way to test. I’ll try it first and confirm using this.

Thanks I will give it a go.

Thanks. Yes, there is. The only one without a wire connected is terminal 2. Here is what it looks like to confirm as well as the wiring diagram from the RBW9 programmer.

Thanks for the reply and explanation. Is there any way I can check if it will work fine set to pumped? The house was built in 2005 and originally had a Worcester Bosch 19/24cbi, I have recently had this changed for a heat only Viessmann 100-W.

I am in the process of replacing my HW & CH programmer. The current Siemens RBW9 unit has the dip switch (5) set as gravity fed. However, I have a grundfoss pump and what I believe to be a Y-plan system with a three way valve, hot water cylinder in the airing cupboard with a cold water tank and...

I am having a new Viessmann 100-W 25kW heat only boiler fitted and trying to decide whether to go with weather compensation or something like a Tado thermostat. Currently we normally use the heating from about 3:30pm in winter until about 8pm on 20c then I let it set back to 15c from 8pm until...

Thanks Freddo!

Hi everyone, I am looking to change my DT90e thermostat for a Danfoss TP7001 (battery version) and would like some guidance / confirmation as to the correct wiring up. I currently have the DT90E with the Brown wire in A and the Black wire with Brown sleeve in B. There is nothing in C, the Grey...

Thank you very much, I followed your clear instructions and now all is working perfectly. Thanks again. :) :)

Hi, I am hoping someone can give me some guidance. The job I want to do is simply to change a dimmer switch for a normal on/off switch. I have done this many times before, but not seen the kind of wiring I have on this one. The dimmer switch is for a bathroom (outside of the door), it also...