Recent content by justsodit

Thanks. It's just an R8. So I'll just use the tamper, alarm, 12 V and 0 V terminals, and ignore the other two. There are four jumper blocks. What are JP3 and JP4 for? And can you tell me please what the up and down adjustment of the detector is for, graduated from 1.5 M to 3.0 M? And the three...

I have bought a Dual Tech sensor AFG-0001 but of course Texecom withhold the installation manuals like they are the nuclear launch codes or something. Can anyone point me to some information about how to install and set up these detectors please?

I have had time to tinker about with it this weekend. Blu Tack on the keypad sounder didn't make much difference, tbh. However, the good news is that I can mute the entry/exit beeps from the control panel using the volume control on the circuit board, without affecting the volume of the high...

Thanks sparkymarka. That would certainly silence the RKP! I was hoping there was a setting I could change so I didn't lose keypress beeps as well. I suppose I could just turn down the panel volume, but does that mean it wouldn't sound the internal high level tone if an alarm is triggered?

I have just installed a Texecom Veritas R8 with its keypad mounted close to the panel. The exit/entry beeps come from both the RKP and the panel, slightly out of sync, which I find a bit irritating. Is there a setting to silence the RKP?