1. Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.
    Dismiss Notice

Adding a Texecom Premier Elite DT to my Veritas R8

Discussion in 'Alarms, CCTV & Telephones' started by justsodit, 15 Aug 2019.

  1. justsodit

    justsodit

    Joined:
    7 Jun 2019
    Messages:
    5
    Thanks Received:
    0
    Country:
    United Kingdom
    I have bought a Dual Tech sensor AFG-0001 but of course Texecom withhold the installation manuals like they are the nuclear launch codes or something.

    Can anyone point me to some information about how to install and set up these detectors please?
     
  2. secureiam

    secureiam

    Joined:
    20 Jun 2014
    Messages:
    3,492
    Thanks Received:
    419
    Location:
    Lancashire
    Country:
    United Kingdom
    You can usually find them online.

    If you have an R8+ you can use resistor settings, if its just an R* then you will have to operate in normally closed mode.
     
  3. justsodit

    justsodit

    Joined:
    7 Jun 2019
    Messages:
    5
    Thanks Received:
    0
    Country:
    United Kingdom
    Thanks. It's just an R8. So I'll just use the tamper, alarm, 12 V and 0 V terminals, and ignore the other two.

    There are four jumper blocks. What are JP3 and JP4 for? And can you tell me please what the up and down adjustment of the detector is for, graduated from 1.5 M to 3.0 M?

    And the three LEDs, what do they tell me?

    I appreciate your help.
     
  4. secureiam

    secureiam

    Joined:
    20 Jun 2014
    Messages:
    3,492
    Thanks Received:
    419
    Location:
    Lancashire
    Country:
    United Kingdom
    look the manual up online stop being lazy, I think your not even trying
     
Loading...

Share This Page