Recent content by keith666

Thanks a million works a treat, dropped the fuse from original down to 5a. Tha ks for the help

Thanks, great info, have some single switches (L1/L2/L3), of i use 2 live wires (supply and outgoing to light) in new switch (L1/L2) and join 2 neutrals? Should be ok? Thanks again

Hi, looking for some info on a replacement switch. Existing one was powering a boiler, single switch with L1/L2 and N1/N2, looking to replace (as damaged) to run a light from. Cant seem to locate the exact match however, any info massively appreciated

Thanks for the advice again much appreciated

Have had a further look, pipe from middle of tank goes to valve and actuator, pipe from bottom of tank has a valve (no handle) but this when shut dosent seem to shut off water. May be more in loft, does the expansion tank have to empty as well? Will investigate in loft shortly

i need to shut water off from HW tank (taps to change and no local shut offs), there is a drayton actuator on main outlet from tank but not sure if there is a manual override to close? Any info/guidance appreciated Thanks

Does anyone have any experience/information on good solutions on how to attempt to insulate noise from ground floor to first in new build(8 years old standard detached house). I am ideally trying to minimise noise from living room which is directly below bedrooms. There seem to be some products...

Thabks for the info, haven't looked at types of insulation yet, is there a specific type of rockwool with soundproofing ability? cheers

Hi, am thinking of replacing an extremely creaky floor (suspect chipboard not on joists) as this will be a kids bedroom and is above living room i was thinking of lifting floor, rejoisting around sides and putting some kind of acoustic/soundproof insulation in. Anyone have any experience of...

Thanks for reply, my thoughts were that it is the tap reducing flow. Its not bad, just slightly less than before and we have a HW tank with no pump. Cheers

Hi, have replaced my kitchen sink for a stainless one and fitted a new mixer tap, single lever with extending spray hose. Has 3 flexi hoses on base of body. Question is: hot and cold water isolated before work, new isolators fitted (as builder neglected to do so), when work done all ok but the...

Thanks again for info. Cheers

Thanks for info, if I wanted to fit TRV's to some rads, can I follow previous procedure and then drain rad system?? Thanks again

Hi, another job i'm looking for guidance on. I am refurbishing the kitchen/utility and want to replace both sinks (have done same thing before) Problem is the "builder" hasn't fitted any shut off valves to either. The house has cold water storage and hot water tank, do i shut off main cold...

Thanks very much sleepyhead, doors off and advice excellent. Just looked a bit odd that the slots weren't all in the same direction. Should have better things to do on a friday night than change door handles though.... cheers again