Recent content by knapdog

Thank you tictic.Have not bought the grout yet but have Topps rapid set flexible adhesive in white for floor and BAL Grip adhesive for walls.

All commissioned to spec. Ceramic wall tiles 50mm stone mosaics for floor Walls are mortar rendered I would prefer to just prime the floor with a good quality primer ( any recommendations?) than using matting. This is a room that will not be used very often. We have decided to have a wet...

The UFH has already been laid on insulation board with a final 100mm screed on top. NuHeat gave very good instructions for installation. It is the warm water type connected to the central heating. I have done lots of tiling in the past but wish to know if I should be doing anything specific as...

The screed has been down about 9 months as we diverted our attentions to jobs outside. I have purchased a flexible adhesive suitable for UFH from Topps Tiles.

In our new extension we have the shell of a wet room 1.8m x 1.7m. In it will be a WC and washbasin. We have NuHeat UFH installed with the floor screeded forming a dip towards the pipe that will be the drainage for the shower. The drainage pipe is a good 45cm away from any wall and the floor...

I have re-sited a Brilliant Romance 16 coal effect gas fire and in transit have broken the two main soft ceramic units that the "coals" rest on. Four of the coal protrusions have broken off and the front piece has broken into three pieces. The cost of renewal is being quoted as close to £100...