Recent content by KSS_1977

Thank you for the reply, it’s going to be tricky but not impossible to move it a few mm. the side that’s against the wall (the long side) opposite has been siliconed in pretty damn good I’m not sure there’s much movement in there. I guess that’s part of the problem, it’s siliconed all the way...

Hi guys, Hoping for some guidance here. Had our bath replaced earlier in the year only to find it’s leaking where the tap end meets the tiles. It’s a shower over bath and the bath is P shaped. Rest of the Bath is water tight and it just appears to be this end. There isn’t much of a gap...

Yes checked all those Pump valves are new ( changed them as the old ones were ropey) Pump is right way around, water tank is full and clear ( cleaned that out by hand on the weekend to ensure no dirt got sucked into the system) rad valves are open. Thanks for the reply.

Hi, it's making a schlap schlap schlap noise sorry if that sounds silly. It's on the lowest setting at the moment ( speed 1) It's also worth noting that if you turn off the CH and HW from the programmer ( so both zone valves close) the pump does go quieter.

Hello Harry, Thank you for the reply, the drained water was OK. Bearing in mind I have drained down last weekend it was relatively clear, no sludge. Thanks for the tip on the inhibitor.

Hello, thank you for your reply. Mine is not pumping over ( as in back into the F & E Tank), the replacement pump is a replacement for the outgoing pump, but a modern day equivalent. Interesting to get the pump to activate without firing the boiler. Thanks,

Hello all, If any of you could help me with a potential answer to this I would really appreciate it. I have a potteron netaheat 80 in an S plan configuration, the boiler is located on the ground floor and has no drain points as such that I can see. So imagine a long run of 22mm flow and return...

No worries :), according to Tado, the relay seldom fails. Indeed, this was the basis of my argument with them (same state config) Else why would they need to know if it's wired or wireless? Since it's battery powered anyway, it's just going to be a case of if that relay is doing anything or...

Hi there, Did you install the Tado system yourself or was it installed by an engineer? As you already have your EK installed it may be easier for you, considering your system is already working with an ST & EK. This is a good question and is why I think you will be OK. Tado asked me at the...

Hi Stem, Thanks for the reply, I have now carried this out and it is now working as expected. Always good to have a second opinion Thank you for your help.

Hi All, After a bit of advice here, I am a tado user and have had the smart radiator valves and smart thermostat for approx 2 years.. The heating system is an S plan system with HW tank in the loft and a Potterton Netaheat 80E which is old but works ok. The system was previously controlled by...