Recent content by leevis

I've been looking at this again, the width of the track that goes vertical is 20mm. Could it be that when it says 852-872 could this mean that is the exact distance it needs to be ie start at 852 and end at 872?

Attached is the diagram which is confusing me, I can't work out whether its saying that the outer extremity of the upright is 872 (W1 for 900) or I just have to put is so that the outer extremity is somewhere between 852 and 872. It's the same on both uprights, I just need to work out exactly...

Hi All I've purchased a shower which is frameless and I need some help in working out how to install the thing. I have the instructions and there is a W1 and a W2 W1 is the width between the wall and the outside of the upright channel that the glass goes into. W2 is the width between the walll...

Hi Hopefully someone can help me, I have a new shed and the previous one had power to a consumer unit inside the shed, there is a join outside. I have moved this and connected it back up but when I flick the shed fuse on the main rcd in the house it trips, none of the consumer unit in the shed...

Yes, when there is no pipe it's fine, I have managed to get it on, over a few threads and gave it a reasonably hard pull and it all stayed together. I think the trap must have crappy threads I think, anyway. Next weekend will test it with water as I need to pop out, hopefully it will hold

Yes, the thread will not grab the nut

Flexi appears to fit fine, if I were to do the nut up without the flexi in it, it seems to go in fine. I have attached a pic of what it looks like when I push the flexi in, I think its because the black seal is sitting proud?

Yeah so I have placed the plastic nut and washer on the spigot and the black seal and done all that, I'll try again, sounds like I'm doing it right, just doesn't seem to want to grab

I bought 2 couplers 40mm and 32mm in the hope that one of these will fit properly and I am at a loss. The actual end of the flexi (I know I shouldn't but I really have to here) is what I have measured at 38mm, this is the blank spigot end. Does anyone know what I need to buy here to be able to...

I think that is probably what I need :)

Hi All hope someone can help me I am trying to fit a new shower and need some advice on the fittings I need regarding plumbing. Currently I have the previous waste pipe which is a 40mm and I have the trap on the show which is also a 40mm. What I need is a flexi which is around 400mm in length...

OK bit of an update, I have managed to get those extenders off of the pipes. This is great because the pipes are no longer going to cause that much of a problem. I am in the process of putting these aqua panel cement boards up, these need to have the mesh put on the joins etc and a bit where...

I think the second part is correct, it's the sliding into the corner that's going to be tricky. Yes I can place it straight but would have to put the corner piece onto the panel first I think? Doesn't everyone have these shower feeds when they are installing these? Maybe these extenders can be...

From what I can see, and I will need to measure this, the holes for the pipes need to be the diameter plus 4-6mm. I am guessing that this is likely to hopefully give enough lateral movement to push the panel into the corner part?

Here are some photos, they stick out about 70mm