Recent content by LenBeach

  1. L

    How to wire a Meross MSG100 to Marantec Comfort 250B

    Hi all. I’ve just moved into a house with a Marantec Comfort 250B installed. The remotes are battered as is the switch in the garage so I’m planning to upgrade to a Meross to give a little more security (knowing the door is shut for example) while ditching the old switches and fobs. My...
  2. L

    Replacing Drayton LP112 with Nest 3rd generation

    Hi all. We’ve just moved into a new house which is a full renovation project. We currently have a Drayton LP112 programmer and a traditional dial thermostat. I’m planning to install my Nest 3rd generation and thermostat. The thermostat will be powered using a plug in power supply so that it...
  3. L

    Any ideas on this basin waste cover?

    This basin waste is fitted to a small Duravit hand basin in one of my partners bathrooms. The chrome has started to peel which looks a bit shabby. We’re looking to sell in the next few months so just tidying up a few details. Replacing the waste is not an option as the underside of the sink is...
  4. L

    Level or secure uneven floor tiles

    Thanks buddy. I used that in the end and Gorilla epoxy to seal the cracked tile. It came up really well.
  5. L

    Level or secure uneven floor tiles

    Hi all, My girlfriend and I are decorating her house and we’ve started tackling the bathrooms. I’ve just regrouted the floor in the main bathroom having removed the old grout and it’s come up really well, I’ve added before and after pictures. I’m just about to start the shower room which...
  6. L

    Eurosec CP8L code reset and Check code

    That’s a great shout!
  7. L

    Eurosec CP8L code reset and Check code

    Thanks buddy. I’ll check that.
  8. L

    Eurosec CP8L code reset and Check code

    My girlfriend moved into her apartment last year which has a CP8L fitted. I know these are commonly discussed and I’ve read a number of the posts and the manual. We don’t have the code for the alarm and the alarm shows a Check fault on the panel. The questions I have, having done some...
  9. L

    Adding inhibitor to Ideal Logic Heat 15/Range Tribube HE unvented system

    I don’t sadly. The house was built in 2012 so potentially before these became commonplace in builds.
  10. L

    Adding inhibitor to Ideal Logic Heat 15/Range Tribube HE unvented system

    Brilliant, thanks Harry. Very comprehensive. I’ll grab the inhibitor tomorrow.
  11. L

    Adding inhibitor to Ideal Logic Heat 15/Range Tribube HE unvented system

    Thanks buddy. I had seen numerous articles about adding via a towel rail which would be much easier. I may just take that route.
  12. L

    Adding inhibitor to Ideal Logic Heat 15/Range Tribube HE unvented system

    Hi, I have an unvented central heating system with an Ideal Logic Heat 15 and a Range Tribube HE invented cylinder with 16 radiators. My intention is to add 2 litres of Sentinel X100 as I recently drained down the system following some pipe work repairs. All of my reading has suggested that I...
  13. L

    Leak from copper pipe in downstairs bathroom, thoughts on how to trace it?

    That was a temporary measure fitted by the trace and access technician. It’s been replaced with copper pipe now.
Back
Top