Recent content by lukejames

No other lights just the amber triangle with exclamation mark.

Hi i have the above van 16 plate with 18,000 on the clock. The service spanner has come on showing - 50 miles as it's due a service but recently a amber triangle with a exclamation mark in it has appeared on the dashboard. I have spoke to a neighbour who say it could be the diesel particle...

Hi looking at installing some led lights in back on van. Purchased some off ebay which are 2 wires connection.Can I connect straight to the interior light to power as I want to come on when rear /side door opens . There are 3 wires going into the interior light . Do I require a link between 1 of...

Hi .I have the above van which packed up today. Lost all power suddenly no noise ,engine malfuntion light came on. AA man came ,checked oil, fuel ,battery . Engine would not turn over. Checked fuel pressure which was 0 so he undid a little bolt on the engine case to see if the timing chain bolt...

Thought as much. Thanks for the reply

Sounds rough when you spin it by hand. Is it repairable ?

Hi all .I have the above machine approx 5 years old. When you turn it on the machine every line flashes for about 30 secs then stops.It never used to do this. Also when spinning the machine is very loud as if something is loose / worn. Any ideas what to look at before I investigate . Many thanks

You need to drain some off from the system. If you haven't a drain off anywhere use a bleed valve on a radiator to do it .

you have spent enough on this heap. Bin it . Horrible boilers

Most of us have learnt not to work for estate/ Letting agents . Scum of the earth in my opinion.

I assume with you messing about in the boiler you are Gas safe registered. If not I would advise you get an engineer in .

Having a issue with my parents dishwasher when you run program it takes forever to complete a cycle. It shows 1 in the display which normally ends the program but it seems stuck on this. Any thoughts before I check anything .

What boiler do you have? Check the pressure gauge ? more details please

As Agile says where the pipes come under the boiler there is normally a label on the frame with GC number & model details . You might need a torch to look closely.

You need to re pressurize the vessel. Have a look in FAQ at the top of the forum.