Madrab's latest activity

  • Madrab
    Madrab reacted to Alec_t's post in the thread Bath tap issue with Like Like.
    As a temporary bodge you could put a rubber band round the tap to provide a barrier for the water.
  • Madrab
    Madrab replied to the thread Bath tap issue.
    Cheaper deck mixers are always a challenge, the rubber seal never seems to be thick enough, nor does it seem to cover the entire...
  • Madrab
    Madrab replied to the thread Solvent weld and rubber boss/branch eye adapters.
    Think we already covered this? https://www.diynot.com/diy/threads/40mm-boss-adapters.655018/
  • Madrab
    Madrab replied to the thread Cleaning / servicing a 3 way valve..
    we know thanks - @denso13 had already pointed that out. It was in response to slowdown response, hence the forum rule not to resurrect...
  • Madrab
    Madrab replied to the thread Replacing tiled shower floor with shower tray.
    If the tile backer board is cementitious and at least 12mm thick, minus insulation, then that should be strong enough, to minimise...
  • Madrab
    Madrab replied to the thread 550mm basin wall hung.
    As long as it's at least medium density, light density would struggle to hold that if any weight was applied IMO.
  • Madrab
    Madrab reacted to denso13's post in the thread Cleaning / servicing a 3 way valve. with Like Like.
    8 year old thread.
  • Madrab
    Madrab replied to the thread shallow bath waste washer.
    As long as the washer is large enough so the edge of the bath waste sits on it so when it's tightened it forms the seal then that'll be...
  • Madrab
    Madrab replied to the thread Cleaning / servicing a 3 way valve..
    Typically 3 way valves do wear out but more so the motors/switches but the valves themselves tend to last for quite a long time, if it's...
  • Madrab
    Madrab replied to the thread shallow bath waste washer.
    It will be a flat washer with that flat face on the inside of the trap, the washer linked to above is more for say a McAlpine 11/2" bsp...
  • Madrab
    Madrab replied to the thread 550mm basin wall hung.
    This is the fixing instructions that come along with that basin, it's also marked that it comes with the required fixings which will...
  • Madrab
    Madrab replied to the thread Toilet handle not level.
    If the syphon is acting up/return sticking etc then TBH it's time to replace it, it's worked hard all it's life and doesn't owe anyone...
  • Madrab
    Madrab replied to the thread Down pipe.
    Certainly get a plumber, experienced in soil stack work, in first. They should be able to assess what all may be needed and suggest if...
  • Madrab
    Madrab replied to the thread Not Getting Hot Enough!.
    Is the system sealed or open vent? If the flow is only reaching 64degC on max then it's not an overheat causing it to cycle, if that...
  • Madrab
    Madrab replied to the thread Toilet handle not level.
    take the plastic arm off the lever and try moving the handle around the square in the plastic arm by a 1/4 turn
Show older items
Back
Top