Madrab's latest activity

  • Madrab
    Madrab replied to the thread Shower tray.
    These days, it depends but TBH the floor should never be out anything much at all. I'll always start with a level floor, even if the...
  • Madrab
    Madrab replied to the thread Replacing tiled shower floor with shower tray.
    Nope - if you get it as part of the tanking kit then you use a primer on the wall and floor, then paint in a coating of the tanking...
  • Madrab
    Madrab reacted to Hugh Jaleak's post in the thread Down pipe with Thanks Thanks.
    You've not caused any bother, don't worry, most of us are here to help and will work through the issue with you. It's not a huge job...
  • Madrab
    Madrab replied to the thread Replacing tiled shower floor with shower tray.
    Sounds like a plan. As suggested, just ensure the cementitious board is thick enough to load bear properly. Sand and cement can be...
  • Madrab
    Madrab replied to the thread Replacing tiled shower floor with shower tray.
    Looking at the pics that may actually be some type of former but most of then are made from SMC/GRP materials. Older ones used to have...
  • Madrab
    Madrab reacted to jasonmav's post in the thread WC waste with Like Like.
    Underground 15° double socket was the solution.
  • Madrab
    Madrab replied to the thread Toilet handle not level.
    I find that most people don't bother with using a short flush for 1's and long flush for 2's. They are a great idea for water saving if...
  • Madrab
    Madrab reacted to Hugh Jaleak's post in the thread WC waste with Thanks Thanks.
    An appropriately angled 110mm bend and cut the pipework to suit. Assuming it'll all be boxed in, so if you need a shallower angle...
  • Madrab
    Madrab replied to the thread Down pipe.
    Absolutely no need to apologise, things happen. This is a public DIY forum and most are here to help, the fact that you aren't on here...
  • Madrab
    Madrab replied to the thread WC waste.
    I think a 45deg bend on the grey with the 90mm adapter on it and then angle the frames soil pipe down @ ~ 45 deg and trim both pipes to...
  • Madrab
    Madrab reacted to CountryFan's post in the thread WC waste with Like Like.
    Wouldn’t go flexible. Maybe extend the grey coming out and 45 into the black on the frame, or offsets?
  • Madrab
    Madrab replied to the thread Not Getting Hot Enough!.
    That could simply be down to a flow issue, where were you getting the temps from? There isn't a flow sensor on these, rather a flow temp...
  • Madrab
    Madrab replied to the thread Not Getting Hot Enough!.
    Took the words right out of my mouth :) @Nelly B - as suggested - if any of the copper pipework attracts a magnet then that's an issue...
  • Madrab
    Madrab reacted to Hugh Jaleak's post in the thread Not Getting Hot Enough! with Like Like.
    Anywhere 'magnetic', i.e. your Magnet is attracted, will indicate Sludge and Crud build up, restricting the flow through the pipework...
  • Madrab
    Madrab reacted to Exedon's post in the thread Not Getting Hot Enough! with Like Like.
    Tank feed / open vent id be checking pipework with a magnet around open vent/ cold feed area.
Show older items
Back
Top