Heya Folks,
I have to fix a type of tap I'm not familiar with.
I have included pictures of it below. The right hand tap does not work, no water comes out at all. Is it a case of replacing the section I'm holding in my hand in picture 2 or does the whole lot need to come out ? If it is a...
Thanks for your quick response Sheds.
So I'm right to do C&G 2330 Level 2 ?
Once completed could I issue an EIC for any work completed or would I have to do Level 3 and/or 2391 or 2382 before I could issue one for my own work ?
Craig
Hello Folks,
I was wondering if anyone could help me out if I'm taking the correct route for what I want to achieve.
Me and partner are looking at moving in the couple of years and as I have done a lot of building and conversion work in our current home (though not electrical) I wanted to...
Hello,
My floor and wall are not true so the shower tray and my wall do not form a 90 degree angle.
When I dry fit the elclosure side panel and upright there is a 2cm gap at the bottom of the metal upright that I have to screw to the wall.
I plan to screw the upright into place using a...
Hello,
Bathroom proceeds okay (albeit a bit slowly) mainly thanks to questions being answered on these forums.
I have another question I need help with.
I want to remove the existing old fashioned radiator for a few weeks so I can do the wall behind then replace it with a new shiny...
Hello,
I've put my tiles up with Wickes waterproof tile adhesive ontop of plasterboard covered with BAL WP1 tanking kit (& primer).
I was wondering can I grout after 24 hours or do I have to wait the 72 for 'Impervious' backgrounds ?
The room is cold/medium temperature, it doesn't...
Hello,
I'm doing my shower enclosure walls, they're standard plasterboard which I'm tanking with BAL WP1 Tanking system before putting the tiles up with waterproof adhesive. I have joined the panels and corners with tape and jointing plaster.
So the qeustion is...
Do I need BAL primer...
Heya Richard,
Thanks for the help.
I was going to use normal plasterboard for the whole room and tank around the shower area (2 walls) with a BAL WP1 Tanking kit. I've been told that with the waterproof adhesive and tiles/grout it should be waterproof enough, is this not the case ?
Craig
Hello,
I'm quite new to the forums but am in need of help.
I have decided to go with dot & dabbing (d&d) my bathroom this weekend and have read many useful, articles here on d&d.
However I am not sure what to do about the window ?
What do I use to join the exposed brickwork of the...
Hello,
I'm new to these forums (as a poster at least) so please be gentle with me.
I've taken the plaster off my bathroom walls and plan on dot & dabbing (d&d) plasterboard for the most part and Aquapanel around the shower.
Now I know this will cause uproar with some as officially you...