Recent content by maidbloke

Really appreciate the guidance, thanks. All sorted now and ploughing my way through the programming manual!

I have a Galaxy 3 144C alarm panel. Cold reboot. It has one keypad connected using a 1k end of line resistor (I do not have a 680 ohm resistor yet). All zones have 1k resistors. The coin cell battery is present but there is no mains backup battery yet. When powered up a red LED on motherboard...

Outside the window is 100cm from the ground. Maidenhead Berkshire. Window is just 56 x 31 cm so I was hoping to find somewhere that would post it to me.

The glass is 130cm from the floor. It's a downstairs toilet. There is a basin directly below the window. Does it need to be toughened? Having trouble finding an online place that will deliver, Google just shows me places that want to sell me the whole window, frame and all.

Great, thanks for the help, really appreciate it.

Sending you virtual kisses! :LOL: That was the vital bit of knowledge I didn't have. Once the inside gasket was removed the outside beading popped off like a dream. I was able to remove the window unit and measure it for a replacement. Presumably when I get the replacement I pop the outside...

I am failing to remove the bottom broken window unit from a double glazing window. The youtube videos make it look dead easy. :mrgreen: I bash my Moon Knife as hard as I can and it only goes in about 5mm. Flexing the knife at that point does not persuade the beading to pop. What am I doing...

Appreciate the advice, thank you both

I have a downstairs toilet with hot and cold water fed from CW tank in loft and HW tank in an upstairs bedroom in a pretty standard late 60's house. Plan is to add shower to downstairs toilet. Tanks to shower location pipe run is approximately 8m. Would I get away with A or do I have to do...

Hi I have an AEG dishwasher, probably 8 years old but it's had a fairly easy life. It's built in. Model Favorit40010VI PNC 911935627/01 I try the 30 minute program. It starts and I can feel water entering the machine through the inlet for a couple of minutes. It fills inside the bottom of...