Recent content by Mark20974

May I say thank you very much to everyone who is helping And advice I'm having a good lot of fun and getting to know my meter very well I do appreciate everything that everyone has done THANK YOU :D :D :D

May I say thank you very much once I get to read this properly and understand it's I will do so and get in contact with you as soon as possible but I do appreciate all your help so far But I do know if it actually is running at 13.6 v at this present time

Thank you how would I go about adding a one amp voltage supply what would I have to do to connect it to and what will I connected to ? :P

Please can you explain DVM testing Thank you for your responses

Yes you are correct the 250 mA is the main fuse No I am not turning off the power issues mains fed constantly What is happening is the thermal fuse keeps tripping out and not charging up the batteries enough I do believe that I am overloading the thermal fuse the reasons why I have two...

hi guys thank you for your help Yes I am getting 13 votes to the battery only briefly before it trips outs it out the only fuse in the panel is the supply fuse which is 250 mA fuse

They are new when I bought a panel Is also I have Metered them

Hi there I have a situation with a low batteries which are Good Alarm panel is brand new system With the alarm system in engineer mode After three days the batteries have recharged up When using system that batteries run down Obviously I am using too much power How can I get over this problem...

HI guys okay the latest update of the situation is as follows removed the battery last night in the morning I tested the battery leads and had a supply I refitted the battery taking it out of engineering mode and seems to be okay obviously I am overloading the system so how might I get...

HI everyone I have just fitted scantronic 9651 2 weeks ago now suddenly amber light shows up on keypad bleeping saying low battery this was all replaced 2 weeks ago where would I start ? the battery is reading 11.74 v dc the outputs is 0074v dc

Hi guys/girls your obvious question which would we do best CCTV system on the market today with night and day resolution with the Audio sound and hard drive to store up to 2 weeks or more for approximately and to record in real time on all countries 12 cameras smart and small easy to wire...

Spoke to manufacturers today they require my old resistors back sending new ones out to me as a technical engineer was not happy with the resistance :lol: 8)

Thank you guys much appreciated your help I cannot believe what it is they always say something easy I have replaced the resistance three times on that circuit so far and tested them and it comes down to being a contact 2K2 tamper resistor blown again must have a bag of dodgy resistance Thank you

Hi guys Okay done some more work on the alarm I have moved the zone from 6 to zone five and this has not made any difference Is saying zone is at fault I have double checked the resistors that they are correct and I have a circuits loop on the system so where am I going wrong mitalee this is...

Thank you for your reply It is a to wire door contact we have two resistors I have done those that way and same as a panic button which works okay I have replaced the wire 2 causes within the wire Thanks