Recent content by Mark62Ellis

I forgot that my Uncle had also bought the Brush cutter saw, that goes on the end of the GTECH. Attached that, and it's also awfully slow. So it's clearly the electric motor that's the issue. Will have to strip the main body apart and look at the carbon brushes, and contacts

The two halves of the moving blads sheer against the other. So the top blade only cuts on the upper teeth (sheering against the bottom blade's upper teeth), whilst the lower teeth are the edge that the bottom blade's cutting teeth sheer against

So, my uncle's Gtech hedge trimmer stopped cutting. The blades move, but don't cut anything. I was trying to cut a tiny lump of grass, and some dead grass and thin bramble strands. Not a chance. I found this wonderful thread, so stripped it down to see if anything was amiss. What I found was a...

Just found your thread by accident. I've lived here 10 years with no problem from the FP715, which is controlling CH and HW on a Mitsubishi Ecodan ASHP. Then on 8th January 2021 - the day I resolved the poor CH running (Immersion not turned up fully, so system stuck on Legionella), I found I...

Oh right, so I got it wrong then :oops: So I need a 240 volt heat thermostat with an override instead?

I have a Fantasia ceiling fan in my lounge. I want a switch that will turn it on when the humidity in the room gets too close / sticky - so that my dogs will be cooled when I’m out. I believe that a humidity sensor would be better than a temperature sensor, as the humidity can be worse than...