By looking at the key it can be read.There are no 0's on a ford key just nos 1-4.
The key has 6 cuts,starting from the one nearest the handle,working down to the last cut which is towards the end of the key.The key begins with T which stands for Tibbe(the name of the key).
So look at the first...
disconnect battery for 5 mins,lift up the plastic trims beside the seat and the door weatherstrip,unplug and reconnect yellow plug.do this on both sides and refit battery wire.test.4 flashes means seat belt pretensioners(buckles)one flash is clockspring(unit behind airbag).if in doubt take to...
Hello pheonix,what you have to do is open the glove box,swing it down and youll see the fuse box.undo the two 7mm bolts and push the two white tangs in to release the fusebox from the metal casing.you then need to lower it down and turn it around.there on the fuse box is the lock fuse...
Hello mate,firstly if your car is under 3 yrs old they should look at it under warranty.some ask for service history but i feel this is not service related in any case.If its not remove your radio and check the cable is located in the knob and also in the heater housing.Really simple to check...
hello keith,i assume this is the 97 shape mondeo.if it is remove the n/s scuttle and remove the pollen filter.you will see two bolts holding the housing to the bulk head.take these out,remove the housing,clean and add a nice bead of silicone to the underneath.also whats worth a look is to make...
hi i live in a 1950s semi and have a wooden ground floor.the floors seem to vibrate when someone walks past.i have tongue and groove boards.Also i have had a quick look under the boards and the joists seem ok in the walls.the only sleeper wall is the room divider which is halfway in a 22 foot...
im assuming its a focus.anyway if the light is on constantly it could be a fuse these are behind the glove box but it sounds more like the control module.this is under the center consol and would prob be best fitted by ford garage as they have to be programmed on computor
if you take the screws off the side and bottom of the trim,
carefully prize off the small trim on the interior grab handle and undo that screw.you can get your hand up the back and reclip the switch back into place.this saves taking off the door trim.
hello again the zone valve is to be fitted so i can control my water temp but like last week when it was very cold i needed to turn up my heating hence the water temp rose and is too hot to touch.i was wondering if this was normal and if not am i doing any harm to the system
1.put key in ign and turn to posistion 1
2.wait for red light on clock to come on(10-20 secs)
3.remove key and get out of car,shut door and point key 2 inchs away from the little window on the outside door handle
4.press the front button down and wait for red light to flash on key
5.keep...
i have a glowworm capricorn 240/6 back boiler and when the boiler stat is just off minimum my rads are hot 21c but my water is very hot.when its cold i turn up the stat(a third of the way round) as i have no room stat and the rads get hotter.but the water feels scolding.i am awaiting a zone...