Think I've found the answer but will wait for confirmation - 5 core cable - N,L,E from receiver to corresponding in the terminal block , 4th wire from common 1 on the receiver to LS in terminal block and 5th wire from 3 on the receiver to LR on terminal block, remove link between LS and LR. I...
Puchased a Hive 1st Gen single channel SLR1b a while back and now looking to install it - I've got the Baxi Combi 33HE with a wireless timer/thermostat.
Terminal block shown - wiring goes to a fused spur.
I've looked on various forums but struggling to find my setup - a walkthrough on...
sorry - should have made it clearer - my shower waste is in 50mm (apart from a small length of 40mm from trap) - my basin starts in 32mm and then goes up to 40mm - this would connect to the 50mm using a T on the way back to the stack.
now doing final runs to stack on my bathroom refit - it will be far easier to join my basin waste into my shower waste (2 " pipe) - have an anti - vac trap for the basin - just wondered how likely it is that this configuration could cause problems later on - any advice appreciated. I can have...
I want to run 1st floor toilet waste under floor - joists run the right way and want to use a swan neck mcalpine pan connector to keep away from joist that runs parallel with wall -
Depth of joists are 165mm and run from pan to stack is 1620mm -
if i put the pan connector into a 92.5...
thanks again richard - my shower waste has a 40mm compression joint - a what point do I change to 50mm ? and once my sink and shower waste meet outside do I then reduce to 40mm on the final bit of run to the stack?
thanks for your help richard - looks like I'll be running 40mm from basin, 50mm from shower and joining them on outside wall. I'm now looking at toilet waste running under the floor as well but there is a joist running 80mm from wall so don't know if I can get waste past it - have picked up the...
I will be starting my bathroom refit next week - would like some views on how to run the waste - have tried to draw a plan showing how waste will run (not brilliantly to scale ) - what I need to know is:
- How should I run the wastes for the basin and shower once they exit the wall - should...