hi there
this is the second pyronix enforcer i have owned the first on when you did not touch the panel for a while would dim but this one just stays bright lit is there something in the setting to make it go dim
i have a pyronix enforcer alarm i want to add a pir to a out building it pars up fine and good signal strenth the question is is there a way of have this pir as independent on system what i mean is i want to leave that senser as set unless i unset that one. So if i go out i can set the whole...
so powered system down unplugged battery and then powered back up mains first but still no communications menu or set up app menu
can anyone help please
at night i set the alarm and all sets fine but when i come down stairs it does not give me time to put code in
the senser that is causing the problem is set to be a entry route
i have the timings set as exit 10 which is fine entry as 15 but it is not giving me 15 and siren 4 which i see is the...
just found out that when i power down and start up again it should be mains first which i did not do but if i power down the system and unplug battery will i lose all my settings and detectors that i have inputted etc
Can someone explain the process for installing bell i thought you just learnt the bell to the system and it was done by going to learn devices-learn bell or is there something else that needs to be done??? do you need to setup the input like you do door detectors etc or something
while you here lol i am fitting bell today do i just go to learn bell and push button like detectors do i need to do anything else i mean with detectors you have to go to the input and set up detector do you have to do anything with the bell like that and if so which menu and what settings...