Recent content by martyheat

Thanks Tony i filled in the my gas registration Martyheat

HI Tony help me out if you can as i have not found were to get into the CC all the best Martyheat

Thanks Plummerman have fitted new thermistor but no change have also contacted Biasi ( i should have asked my wife she knows more) many thanks martyheat

Hi tony yes i am R G I I will try and find were i have to register many thanks martyheat

Thank you for your information,we do seem to have a good flow through the plate unit on the primary side , do think its possible its not enough??? martyheat

5 years ago we fitted a biasi 28 combi in a new system which was chemically flushed and a inhibitor added, after 18 months while under warranty the pump failed, biasi engineer told customer system required to be power flushed, we removed a rad, the water was clear and clean but we power flushed...

HI all we have a sealed hot water cylinder each time we turn on hot water tap we get cloudy water which does clear after a short time, any one have any way to stop this.

Well Tony my thinking is that any input heat as from a heatpump at 40c would mean the oil boiler i have would only be required to heat at 40c to give a 80c output ??????

I have an oil system costing £50 a week in the cold spell ,which is to much for a 3 bedroom 9" solid wall.I would like to insulate outside walls but my wife does not want the mess.

Any one fitted a heat pump and connected to an existing heating system. the system i have is an s plan with an unvented cylinder.

Thanks i will get keston to call again

Hi Andygasman the display is as if unit is showing temp around 45 and the rad symbol many thanks Martyheat

Have a keston qudos 28s boiler that at times does not start for some times up to 15-30min. electric to unit ok, its not the overheat stat as it can happen 1st thing in the morning .any help ????

Hi there its not to much of a problem just change the waste trap for one with an air admittance valve fitted on the trap martyheat

HI HAVE DONE MANY WET ROOMS NO 1 CHECK WERE AND HEIGHT OF DRAIN YOU ARE CONNECTING TO SPEND TIME IN GETTING CORRECT WASTE TRAP AND SETTING IN SCREED CORRECTLY, AND WERE TO POSITION TRAP IS VARY IMPORTANT NO 2 TILES ON FLOOR ARE NOT THE BEST WAY AS CAN...