Recent content by MattT

Thanks I have seen that, it helps with the distortion level but unfortunately not the scale.

Hi All, We are having new windows fitted and need to choose the bathroom window glass design. We are between Arctic (which we already have) and Tribal. Two totally different patterns and slightly worried Tribal will look too fussy. It all depends on scale. Has anyone got a photo of tribal in...

The other devices are showing a signal, but I could walk test it as a double check. Agree it's weird, wonder if I clipped the learn button and it reset it. Seems unlikely though

I did and it didn't recognise it i.e 0 signal, seems like it's lost its registration to the panel or is just simply faulty. Thanks for the tip on how to install

They are I also just checked the signal in engineer mode and it seems both the shock and the MC elements are showing as zero signal, which tells me for some reason this sensor is not communicating with the panel. So I am thinking I should just delete it from the wireless device list, and both...

Hi, this is the photo of the PCB https://i.ibb.co/8D9kTbjb/Screenshot-20250128-190136.png

It stays red (1st led) regardless of the door being open/close however the third led at the end goes green or off when away/near the magnet . It doesn't reset with both tamper's pushed in

An update: 1) I found the "Utility" DT sensor with low battery and that code has cleared following a new battery being installed 2) I tested the tamper on the magnetic sensor and it doesn't seem to be the tamper as the light goes off when both tampers are pushed in. So I am thinking it isn't...

Thank you, I will check that. As I only saw the front tamper and when I clicked that, the lights reacted. It's odd, it's still holding the PIR tamper fault as well. I was wondering if the tampers don't clear until that "DT low battery" warning is resolved, I just need the time to go up on...

If you look at the top left of the door, you will see the door contact sensor, it's black so not easy to see. edit: I took a photo this morning.

I think because the installer decided that would cover the glass if anyone came through it or presumably if they got up there and started looking through that window. It does seem they were "creative" as they also strapped a PIR into the car footwell of the previous owners car, so it was linked...

Hi sparkymarka So these are the three devices in the utility. The battery in the shock that I changed a few months ago. The PIR (2x varta CR123) and the door contact sensor one varta CR123 (black one hiding at the top left) are pictured below. Can send close ups if if that helps.

Thanks T1GERIII both the cover on the door contact and the PIR are back on and secured back by screw (along with their respective new batteries). I might take another look at these tomorrow, but it does seem odd that they both are flagging as tamper rather than low battery, then there is the...

Hi All, So I have a Pyronix enforcer (with the WiFi module) fitted around 2022. Albeit I don't know who by, as we bought the house in 2024. I changed all the shock sensor batteries a few months ago and one PIR that was flagging as low, but not any of the other contact sensors or PIRs...

Thanks, I did exactly that and all resolved now.