I have issue with wok burner issue.
The outer ring do not burn, but inner one burns fine.
I have had all the burners and jets cleaned.
Can anyone plz advise.
I have problem when turning on shower no hot water is available, however hot water taps in bath and sink works fine.
The boiler valliant VCW gb242 do not fire up when shower is on. The shower has been working fine up till now.
Any advice/help is greatly appreciated and thanks in advance.
There was absolutely NO PRESSURE in the EXV (External Vessel), i don't think it has ever been pressurized.
Set pressure to 1bar in EXV and then on the dial, and switched the CH and pressure hardly goes past 2bar, and no leak at all.
Was dreading the worse (replacing the EXV) which would have a...
Tony,i have inherited another problem, the pressure drops to 0 after when CH is off.The overflow drips only a drop when the pressure reaches 2.5-3bar.
How/where/what can i check what is at fault( ie PRV,EV, boiler pressure)?
Thanks in advance
I have recently noticed that the pressure settles to 0 when the CH is off, but the CH will start up with no problem at 0 (have can that be?).
When the CH is running the pressure goes upto nearly 2.5-3bar and i have noticed a little drip(drop) on the over flow pipe outside.
Can it be faulty...
Thanks Tony,will try that later, but are you suggesting there is nothing wrong with the setting as is (5min on and 9 off) as my first post.
Anyway how do i reset the screw to factory setting 5min?
What is the time delay between burner (on/off) when the CH is ON, at the moment my boiler is set to dial 5 and the timing is 5mins burner ON and 9mins OFF (delay), is this normal?
For some reason the timing/delay screw has been adjusted recently by the engineer, and i feel that time/delay...
Help with Veritas R8, tamper light and zone 2
Can not reset the alarm using the correct code(it bleeps), for some unknown reason the control panel tamper light(flashing) and zone 2 is lit up, both in red. None of the buttons on the control panel are responding so I can not reset it or check...
I have leak at the top of tap fitting on our a monobloc mixer tap.
It works by lifting (tilting back) a handle on the top and turning the handle to either the left or right to control the heat of the water. The problem is, when it is turned off it leaks from the top around the swivel part (i...